The air filter is located inside a rectangular plastic air-box in the engine bay, usually on the passenger side. Access it by releasing the clips or screws on the lid and lifting it off. This is the quick answer you’ll use when you need a quick check or replacement.
Chrysler 200 models from 2011 to 2017 were offered with two main engines: a 2.4-liter Tigershark four-cylinder and a 3.6-liter Pentastar V6. In both cases, the air filter sits in a dedicated housing connected to a large intake hose that leads to the throttle body. Exact mounting can vary slightly by year and trim, but the air box is generally easy to reach from the passenger side of the engine compartment.
Engine options and air filter location
Here are the typical air box locations for the two common engines you’ll find in the Chrysler 200.
2.4L Tigershark I4
- The air filter housing is on the passenger side of the engine bay, toward the front. It is a rectangular black plastic box with a large intake hose connected to the throttle body.
Concluding: In the 2.4L Tigershark setups, you’ll most often find the air box close to the passenger-side fender/quarter-panel area, making it straightforward to access from above the engine bay.
3.6L Pentastar V6
- The air filter housing is also on the passenger side, but some model years position it a bit closer to the center of the engine bay. The lid is secured with clips or screws, and a sizable intake tube connects to the throttle body.
Concluding: For the 3.6L Pentastar, the air box remains in the same general vicinity as the 2.4L, though exact placement may shift slightly depending on year and nearby components.
How to inspect or replace the air filter
If you’re planning to inspect or replace the filter yourself, follow these practical steps to keep the engine breathing clean air.
- Park on a level surface, engage the parking brake, and turn off the engine. Open the hood and locate the air-filter housing on the passenger side of the engine bay.
- Release a few clips or unscrew the fasteners holding the lid, then lift the lid straight up to expose the filter.
- Carefully remove the old filter. Check it for dirt, cracks, or moisture; replace it if it’s dirty or damaged.
- wipe the inside of the housing with a clean rag if needed. Do not use liquids that could get into the intake path.
- Insert the new filter with the arrow on the filter pointing toward the engine (the direction of airflow). Ensure it sits evenly and seats properly in the housing.
- Reinstall the lid and fasteners or clips, reconnect the intake hose if it was removed, and double-check that there are no gaps or loose connections.
- Close the hood and, if you notice a misfire or rough idle after replacement, start the engine and listen for unusual sounds indicating a leak.
Concluding: Regularly replacing the air filter at your vehicle’s maintenance intervals helps optimize fuel efficiency and engine performance. If in doubt, consult the owner's manual for the exact service interval for your engine and trim level.
Summary
In most Chrysler 200 models, the air filter sits inside a rectangular air-box in the engine bay, typically on the passenger side. The exact location is similar whether you have the 2.4L Tigershark or the 3.6L Pentastar, though minor mounting differences may exist by year. Replacing the filter is a straightforward task that involves opening the housing, swapping in a new panel filter with the correct orientation, and reseating the lid securely. Refer to your owner's manual for the recommended replacement interval and model-specific details.
Can a bad air filter cause a misfire?
In extreme cases, an engine will run very roughly when its air filter is too dirty. A driver may notice their vehicle's engine misfiring, vibrating excessively, stalling, or a combination of these symptoms when the engine's air filter is clogged.
Where is the air filter in a Chrysler 200 2016?
The cabin filter is located on the left corner of the footwell remove the side panel.
What are three symptoms of a clogged cabin air filter?
3 Signs Your Cabin Filter is Clogged
- There's Little Flow. The cabin filter is, essentially, a component of the air conditioner structure in your car.
- Dust. Another sign is is that you're seeing more than the usual amount of dust and debris inside your car.
- Less Vehicle Power.
Where is your engine air filter located?
Now we just lift off the cover. And there's our filter. Now let's go ahead and remove. It. And you can see it's a little bit dirty.