The typical cold tire pressure for a 2010 Honda Civic is 32 psi in each of the four tires, with the spare tire at 60 psi. Always verify the exact values on the door jamb placard for your specific trim and tire setup.
Official specification for the 2010 Civic
Automakers print the recommended pressures on a tire information placard located on the driver's door jamb and in the owner's manual. For most 2010 Civic models, the standard recommendation is 32 psi for both front and rear tires when cold. If you’re running a different tire size or aftermarket wheels, the exact numbers can vary, so always confirm with the label for your vehicle.
Note on tire sizes
While the exact numbers can shift with tire size and load rating, the prevailing guidance for the 2010 Civic remains 32 psi for front and rear tires in typical configurations. The spare tire is usually inflated to 60 psi and should be checked periodically just like the main tires.
How to check and adjust tire pressure
To help you maintain proper pressure, here is a practical, step-by-step approach you can follow.
- Check tires when they are cold, ideally before you drive or after the car has been parked for several hours.
- Remove the valve cap from the tire's valve stem and attach a reliable tire pressure gauge.
- Compare the measured pressure to the vehicle's recommended cold pressure from the door jamb placard or owner's manual.
- If a tire is underinflated, add air in small increments, then recheck frequently until you reach the recommended pressure.
- If a tire is overinflated, release air gradually until the gauge reads the recommended pressure.
- Replace the valve caps securely and recheck all four tires after adjustment.
Maintaining the correct pressure helps ensure proper handling, even tire wear, and better fuel efficiency.
Spare tire considerations
The 2010 Civic's temporary spare is typically inflated to 60 psi. Do not drive long distances on a temporary spare, and return to regular tires as soon as possible. If your spare is not labeled with a number, consult the owner's manual for guidance.
In short, the standard recommendation for a 2010 Honda Civic is 32 psi for the four main tires, with the spare at 60 psi. Always verify on the door jamb label and adjust for any nonstandard tire sizes or seasonal tires.
Summary
For everyday driving, keep your Civic’s tires at 32 psi cold in the four main tires and 60 psi in the spare. Check regularly, especially with changing seasons and tire replacements, and rely on the door jamb placard or the owner’s manual for your exact configuration to ensure safety, performance, and efficiency.
Should my tires be 32 or 35 PSI?
Most passenger cars' psi requirement will be between 30 to 35 psi, but several vehicles fall outside of that range and every vehicle will have specific requirements. Good tire air pressure ensures that tires wear evenly, provide a smooth ride, and increase fuel efficiency.
Is 40 PSI too high for a car?
No, for most cars a tire pressure of 40 psi is too high. You might find 40 psi suitable for some vehicles, especially if they're carrying heavier loads or if the manufacturer's recommendation is close to that figure. However, it's generally too high for most passenger cars, which usually recommend between 30-35 psi.
What PSI should my 2010 Honda Civic tires be?
Touring All-Season Tire
| Tire Size | (OE) 205/55R16 |
|---|---|
| Repl. Pressure (F/R) | 32/32 psi |
| Load / Speed | 91H |
| Load ID | SL |
| Sidewall | B |
Is 35 PSI good for a Honda Civic?
If your tire pressure is low, the weight of your vehicle could put more pressure on the tires which could result in premature wear and damage. Most Honda sedans, like the Civic and Accord, require 32 PSI (pounds per square inch). Honda SUVs, like the Honda Pilot or Passport, require 35 PSI for their tires.