The front wiper blades for the 2016 Honda Fit are typically 26 inches on the driver's side and 16 inches on the passenger's side.
In practice, the 2016 Fit uses a two-blade setup on the front windshield. The driver-side blade is longer to sweep a larger area, while the passenger-side blade is shorter. The most common OEM sizes for US-market models are 26 inches on the driver side and 16 inches on the passenger side, though some aftermarket sets may offer 26"/17" configurations. To be sure, check your current blades or consult the owner's manual.
Front wiper blade sizes for the 2016 Honda Fit
Below are the typical blade lengths used on the 2016 Fit. These measurements apply to the standard two-blade setup found on most models and trims.
- Driver-side blade: 26 inches
- Passenger-side blade: 16 inches
These sizes cover the vast majority of 2016 Fits sold in the United States. If you have a regional variant or aftermarket mounting differences, confirm by removing the old blade and measuring, or by checking the vehicle’s manual or parts guide.
Verifying sizes and choosing replacements
If you’re unsure about the correct lengths, use these quick checks to verify before buying replacements.
- Inspect the existing blades and note the printed length, usually molded on the blade or packaging.
- Measure the blade length with a tape measure from tip to base to confirm the official length.
- Match the driver-side length to 26 inches and the passenger side to 16 inches, unless your measurements indicate a different configuration.
- Choose a replacement set that explicitly lists 26" and 16" as the blade sizes for the 2016 Honda Fit.
After purchase, install the blades according to the package instructions and test with a few wipe cycles to ensure full coverage and no streaking.
Installation basics for new wiper blades
Replacing wiper blades is a straightforward task, but mounting methods can vary by blade design (hook, bayonet, or pin fittings). Here are general steps to guide you, keeping safety in mind.
- Lift the wiper arm away from the windshield until it stays in a raised position.
- Release the old blade by pressing the release tab or button on the connector and slide it out of the arm’s hook or slot.
- Attach the new blade by sliding it into the connector until you hear or feel a click, ensuring a secure fit.
- Lower the wiper arm back onto the windshield and perform a test wipe for proper contact and coverage.
If the blade doesn’t seat properly, consult the blade packaging or your dealer for model-specific mounting instructions.
Summary
For a 2016 Honda Fit, the standard front wiper setup is 26 inches on the driver’s side and 16 inches on the passenger’s side. Always verify by checking the existing blades, measuring, or consulting the owner's manual or parts catalog. When in doubt, use a 26"/16" two-blade replacement and follow the installation steps to ensure clear visibility in all weather conditions.