The front wipers on a typical 2002 Dodge Dakota are usually 16 inches on the driver’s side and 20 inches on the passenger’s side.
Wiper blade sizes can vary slightly depending on cab configuration (regular cab versus extended/cab), trim level, and aftermarket replacements. If you’re unsure, it’s best to verify against your vehicle’s manual, the door jamb specification, or by measuring the current blades before purchase.
Common front wiper sizes for the 2002 Dodge Dakota
Below are the sizes most frequently used on 2002 Dodge Dakota pickups. These reflect standard OEM or commonly stocked aftermarket replacements for the front windshield.
- Driver’s side blade: 16 inches
- Passenger’s side blade: 20 inches
Note: Some rare configurations or aftermarket setups may use slightly different lengths. If your vehicle has been modified or you’re unsure about your exact cab type, double-check to ensure a proper fit.
How to confirm the correct size for your specific truck
To avoid buying the wrong blades, use the following verification steps.
- Check the owner's manual or the sticker on the driver's door jamb for the listed blade lengths.
- Remove a blade and measure its length from tip to tip using a tape measure.
- If in doubt, consult an auto parts retailer with your VIN or vehicle configuration to pull the exact requirement.
Verifying sizes ensures you get the proper coverage and fit, especially if your Dakota has a non-standard cab or has recently had aftermarket replacements installed.
What to know about rear wipers (if equipped)
Some Dakota models may have a rear window wiper. Rear blade sizes vary and are not the same as the front wipers, so treat them separately if your vehicle has one.
In any case, focusing on the front windshield wipers will cover the primary visibility need for most drivers.
Summary
For a 2002 Dodge Dakota, the typical front wiper sizes are 16 inches on the driver’s side and 20 inches on the passenger’s side. Always verify against your specific cab configuration and manual, and consider measuring the current blades or consulting a parts specialist to ensure a perfect fit.