The short answer: The 2015 Renegade uses a 5-lug pattern on a 110 mm circle with lug nuts that thread onto M14x1.5 studs.
Beyond the quick answer, this hardware detail matters for wheel compatibility, safety, and service. If you’re using aftermarket wheels or different trim levels, confirm with the owner’s manual, the door jamb sticker, or a dealership to ensure you have the correct lug hardware.
Technical specifications
Key measurements you need to source and fit wheels properly on a 2015 Renegade are summarized here.
- Bolt pattern: 5 studs on a 110 mm circle (5x110).
- Lug nut thread size: M14x1.5.
- Lug nut seat type: 60-degree conical (typical for OEM and many aftermarket wheels).
The above specs cover the common configuration for the 2015 Renegade. If your vehicle has aftermarket wheels or a special trim, verify the exact hardware required with documentation or a professional.
Installation notes and verification
Proper installation ensures safety and wheel performance. Here are practical steps to follow.
- Torque: Tighten lug nuts to about 95 ft-lbs (129 Nm) as a typical specification; always confirm the exact value in the owner’s manual or with a dealer, especially if your wheels require different hardware.
- Pattern and seating: Use a star or crisscross pattern when tightening, and ensure the lug nuts seat flush against the lug surfaces.
These practices help prevent wheel loosening, run-out, and other safety issues during normal driving and high-stress conditions.
Summary
In short, for a 2015 Jeep Renegade the standard wheel hardware is a 5x110 bolt pattern with lug nuts that thread onto M14x1.5 studs, using a 60-degree conical seat and typically torqued around 95 ft-lbs. Always verify exact values for your specific vehicle and wheel setup with official sources.