The 1999 Honda Recon 250 uses a 12-volt sealed lead-acid battery, with a capacity typically in the 4–7 Ah range. Common direct-fit replacements you’ll see are models like YTX5L-BS and YTX7L-BS, but exact fit depends on regional specs and production year.
Battery basics for the Recon 250
The Recon’s electrical system runs on a standard 12-volt battery designed to start the engine and power basic accessories. The stock unit is sized to fit the under-seat compartment while delivering reliable cranking performance.
Common replacement options
When shopping for a replacement, the most frequently used group sizes for this model fall around the 12V, 4–7 Ah range. The two widely compatible direct-fit options are listed below.
- YTX5L-BS or equivalent 12V battery (approximately 4–5 Ah)
- YTX7L-BS or equivalent 12V battery (approximately 6–7 Ah)
Note: exact capacity and fit can vary by manufacturer and production year. Always verify the label, tray fit, and terminal orientation before purchasing.
How to verify the correct size for your bike
To ensure you select the right battery for your specific machine, follow these steps:
- Check the current battery label for voltage, capacity (Ah), and part/model number.
- Measure the battery compartment or compare with the dimensions of the replacement option to ensure a proper fit.
- Compare the terminal layout (positive/negative) with your wiring harness to ensure compatibility.
If you’re unsure, consult a Honda dealer or a local parts retailer with your bike’s year, model, and region to confirm the exact recommended battery size.
Conclusion
For a 1999 Honda Recon 250, you should expect a 12-volt sealed lead-acid battery with about 4–7 Ah of capacity. The most common direct-fit replacements are YTX5L-BS and YTX7L-BS, but always confirm fit by checking the label, tray dimensions, and terminal layout.
Summary
In short: a 12V battery around 4–7 Ah is typical for the 1999 Honda Recon 250, with YTX5L-BS and YTX7L-BS being the most common replacement options. Verify fit before buying by checking dimensions and terminal configuration.