Direct answer: The Renegade uses a 5-lug, 110 mm bolt circle (5x110) and lug nuts that thread onto M14 x 1.5 studs, typically needing a 21 mm socket for installation or removal.
In practice, this setup covers most model years, but there can be variations by year, trim level, or regional market. Always verify for your exact vehicle using official specs or a dealer.
Bolt pattern and lug nut basics
The wheel system on the Renegade is designed around a 5-lug configuration with a 110 mm bolt circle. The common lug nut size is M14 x 1.5 with a 60-degree conical seat, and the lug nuts typically use a 21 mm hex head for tightening and removal. Some early or regional variants may differ, so confirm with your VIN or owner’s manual if you’re planning replacements or upgrades.
To verify the exact hardware for your Renegade, you can proceed with these checks:
- Consult the owner’s manual or the door‑jamb sticker for the wheel and lug nut specifications, including bolt pattern and nut size.
- Examine an existing lug nut or the wheel’s install socket to confirm the hex size (a 21 mm socket is typical for M14 x 1.5 nuts).
- If ordering replacement parts, provide your VIN and model year to the dealer or parts catalog to ensure you get the correct lug nuts or wheels.
- When buying aftermarket wheels or lug nuts, ensure compatibility with 5x110 bolt pattern, M14 x 1.5 thread, and proper seat type (usually 60-degree conical).
Conclusion: For most Jeep Renegade models, you should expect a 5x110 bolt pattern with M14 x 1.5 lug nuts and a 21 mm socket, but always double‑check against your specific VIN/year to avoid fitment issues.
Torque and installation notes
When torquing lug nuts, follow the manufacturer’s torque specification and use a star-pattern sequence. Typical Renegade torque values fall in a broad range around 100–120 ft-lbs (135–162 Nm), but verify exact numbers from your owner's manual or dealer documentation for your wheel size and trim.
Summary
In short, the Jeep Renegade generally uses a 5x110 bolt pattern and lug nuts with M14 x 1.5 threads, commonly installed with a 21 mm socket and a 60-degree seat. Always confirm with your vehicle’s VIN/year or official spec materials when buying parts or replacing wheels.