They are standard M12 x 1.5 lug nuts with a 60-degree conical seat, typically requiring a 19 mm socket for installation or removal. The recommended torque is about 80 ft-lb (108 Nm) per lug nut, depending on exact trim and wheel specification.
Lug nut specifications
The following details cover the core measurements and seat type you’ll encounter on a 2019 Accord.
Thread size and seat type
These lug nuts use a standard metric thread and a common wheel-seat design.
- Thread size: M12 x 1.5
- Seat type: 60-degree conical (common on Honda wheels)
These specifications are typical across most 2019 Honda Accord trims and are compatible with replacement lug nuts designed for Honda vehicles.
Socket size and installation tips
To loosen and tighten the lug nuts, use the correct socket or lug wrench along with appropriate technique.
- Socket size: 19 mm
Use a torque wrench when tightening to ensure the correct clamping force, and always follow a star/ crisscross pattern to equalize torque across the wheel.
Torque specification
Proper torque helps ensure wheel retention and even clamping force.
- Recommended torque: 80 ft-lb (108 Nm) per lug nut
After initial tightening, recheck torque after a short drive to account for any settling, especially if wheels or lug nuts were recently serviced.
Notes on trims and compatibility
While these specs cover the majority of 2019 Accord models, there can be variations for certain wheel packages or aftermarket setups. If you have aftermarket wheels or a non-standard lug kit, verify compatibility with the wheel manufacturer and consult your owner's manual or dealer for the exact requirements.
Summary
The 2019 Honda Accord typically uses M12 x 1.5 lug nuts with a 60-degree conical seat, and a 19 mm socket is standard for removal and installation. The advised torque is around 80 ft-lb (108 Nm) per lug nut, applied in a proper sequence. For any deviations due to aftermarket wheels or trims, check the official manual or contact a dealership for precise guidance.