The lug nuts on a 2005 Honda CR-V use M12 x 1.5 threads, require a 19mm hex socket, and are typically tightened to about 80 ft-lbs (108 Nm).
That year’s CR-V is part of its third-generation lineup (produced from 2002 to 2006). Most models roll on five lug nuts per wheel with standard 60-degree conical seats. If you’ve swapped to aftermarket wheels or spacers, sizes and torque may differ, so it’s important to verify against your specific setup.
Factory lug nut specifications
The following specs apply to the factory wheel configuration on the 2005 CR-V. If your wheels are aftermarket or modified, sizes may vary.
- M12 x 1.5 wheel stud/thread size
- 60-degree conical (60°) seat for proper seating in the wheel
- Hex size required to tighten/loosen: 19 mm
- Number of lug nuts per wheel: 5
- Recommended torque: 80 ft-lbs (108 Nm)
These specifications cover the standard factory setup. If you have aftermarket wheels, accord with the wheel manufacturer and your service manual to confirm the correct lug nut size and torque.
What to check if you’re upgrading or working on the car
When dealing with non-stock wheels, always verify the lug nut dimensions, seat type, and thread pitch specified by the wheel manufacturer. Also ensure you re-torque after installation, per your vehicle’s guidance or the wheel supplier’s instructions, to account for the new components and breaking-in period.
Summary
The 2005 Honda CR-V typically uses five lug nuts per wheel with M12 x 1.5 threads, a 60-degree conical seat, and a 19mm hex size, tightened to about 80 ft-lbs (108 Nm). Always confirm with your specific wheels and consult the owner's manual or dealer if you’re using aftermarket parts.