Across most Mazda CX-5 models, the front wiper blades are 26 inches on the driver’s side and 17 inches on the passenger side, with a rear blade of 11 inches if the vehicle is equipped with a rear wiper. This sizing holds for many model years, but exact measurements can vary by year, market, and trim level.
The following information covers typical sizes used on CX-5s and provides steps to verify the right fit for your specific vehicle. Always double-check with your owner’s manual or Mazda’s parts catalog to confirm exact measurements for your car.
Front wiper blade sizes
Most CX-5 models use a standard two-blade front setup. The sizes below apply to the vast majority of model years, but there can be exceptions.
- Driver-side blade: 26 inches
- Passenger-side blade: 17 inches
These are the common front-wiper lengths found on many CX-5s from the early-2010s through the present. For an exact match, verify with your specific year and market configuration.
Rear wiper blade size
If your CX-5 has a rear wiper, the typical rear blade size is 11 inches. Some regional or trim variations may differ, so it’s best to confirm for your model year.
- Rear blade: 11 inches
Always confirm that your CX-5 actually uses a rear wiper blade and that the 11-inch measurement aligns with your vehicle’s hatch design and year.
How to confirm exact size for your CX-5
To ensure you buy blades that fit perfectly, use these verification methods. They help account for year-to-year changes and regional differences.
- Check the owner’s manual or Mazda official parts catalog for your specific year and market.
- Inspect the label on your current blades or measure the blade length directly.
- Use a retailer’s fitment tool by entering year, make, model (and trim) or VIN to pull compatible blade sizes.
- When in doubt, bring the current blade or your vehicle information to a parts counter to confirm compatibility.
Following these steps will help you ensure you’re purchasing the correct blades for your CX-5, avoiding misfits or unnecessary returns.
Replacement tips: quick guide
If you prefer to replace blades yourself, here’s a concise guide to get it done quickly.
- Lift the wiper arm away from the windshield until it stays upright.
- Press the release tab on the blade’s connector and slide the old blade out.
- Attach the new blade with the connector until it clicks into place.
- Lower the wiper arm back onto the windshield and test to ensure full contact and no streaking.
Test the new blades at low speed to ensure proper contact across the glass. If you notice skipping, streaking, or poor contact, recheck the blade size and installation.
Summary
For most Mazda CX-5 models, plan for front blades of 26 inches (driver) and 17 inches (passenger), with an 11-inch rear blade if your vehicle has a rear wiper. Sizes can vary by year and market, so verify with the owner’s manual or Mazda’s parts resources for your exact vehicle. When replacing blades, follow the simple steps above or consult a parts professional to ensure a precise fit.