The 2018 Hyundai Tucson takes the Hyundai Genuine Oil Filter, part number 26300-35500. This article explains what to use, how to verify compatibility, and how to replace it.
Overview of the oil filter for the 2018 Tucson
The Tucson relies on a standard spin-on oil filter. The most common OEM part used for 2018 models is 26300-35500, which fits the typical engine configurations offered in that year. To be certain you’ve got the correct part for your specific vehicle, confirm the fit against your VIN or consult a Hyundai parts retailer with the exact engine code.
Engine options in 2018 Tucson
In 2018 the Tucson was offered with at least two gasoline powertrains in many markets: a 2.0-liter inline-four and a 1.6-liter turbocharged inline-four. Both of these engines utilize a spin-on oil filter and are commonly serviced with the same Hyundai Genuine Oil Filter part number 26300-35500, though regional variations can occur. If you’re outside the main market or have a non-U.S. variant, check the parts catalog or with a dealer to confirm the exact filter for your engine code.
Where to buy and how to verify
To ensure you purchase the right filter, use the following guidance and verify against your vehicle’s specifics.
- Hyundai Genuine Oil Filter — Part number 26300-35500 (recommended for most 2018 Tucson models).
For best results, always verify the part against your VIN or consult a dealer or parts retailer with your engine code to confirm compatibility before purchase.
Maintenance: how to replace the oil filter
If you plan to replace the oil filter yourself, here is a practical step-by-step guide to follow. It’s designed to cover the typical 2018 Tucson procedure, but always consult the service manual for your exact configuration.
- Warm the engine, then park on level ground and engage the parking brake. Turn off the engine and, if possible, remove the oil filler cap to vent pressure.
- Place a drain pan beneath the engine. Remove the oil drain plug and let the old oil drain completely.
- With the oil drained, use an oil filter wrench to loosen and remove the old oil filter. Keep the area clean as oil will spill from the housing.
- Lightly coat the new filter’s gasket with clean engine oil.
- Install the new filter by hand until the gasket contacts the mounting surface, then tighten an additional 3/4 to 1 full turn. Do not overtighten.
- Reinstall the drain plug and torque to the manual’s specification. Refill the engine with the recommended oil type and amount for your engine.
- Start the engine, check for leaks around the filter and drain plug, and then verify the oil level with the dipstick, topping up if necessary.
Following these steps helps ensure a proper seal and avoids leaks. If you’re unsure about torque specs or exact oil capacity for your engine, consult the owner’s manual or a Hyundai service professional.
Summary
For most 2018 Hyundai Tucson models, the recommended oil filter is the Hyundai Genuine Oil Filter, part number 26300-35500. Always confirm compatibility with your specific engine code or VIN, and follow Hyundai’s oil-change guidelines and replacement steps to maintain engine health.