Most 2013 Civics with the 1.8-liter engine use Honda Genuine Oil Filter 15410-PLM-A01, while the 2.4-liter Civic Si uses 15410-PRB-A01. Always verify by VIN or owner's manual, since part numbers can vary by market and trim.
Engine configurations for the 2013 Civic
The 2013 Civic lineup in many markets includes two primary engine options. The majority of Civics use the 1.8L i-VTEC engine, while the Civic Si employs a 2.4L engine. Each engine type has an associated original equipment (OE) oil filter to ensure proper fit and protection.
1.8-liter i-VTEC (R18A1)
Oil filter: Honda Genuine Oil Filter Part Number 15410-PLM-A01. This filter is designed to fit the 1.8L engine powering most non-Si trims in many markets.
2.4-liter engine used in the Civic Si
Oil filter: Honda Genuine Oil Filter Part Number 15410-PRB-A01. This filter corresponds to the 2.4L engine found in the Civic Si in the U.S. and some overseas markets.
Note: Part numbers can vary by market and production run, so verify with your VIN and the official Honda parts catalog if you’re in doubt.
How to verify the correct filter for your vehicle
To ensure you’re buying the right filter, use a market-appropriate method to confirm the exact part number for your car.
- Check the owner's manual or service manual for the exact oil filter part number for your engine code and market.
- Enter your VIN in an official Honda parts catalog or ask a dealer to pull the exact oil filter P/N used on your vehicle.
- If you’re shopping aftermarket, look for filters listed as compatible with either the 1.8L R18A1 or the 2.4L K-series engine, and confirm thread size and gasket type.
Confirming the correct part number helps avoid installing an incompatible filter that could affect oil pressure and engine protection.
Replacing the oil filter: quick guide
The process is straightforward and uses common tools. Gather the oil, filter, and a drain pan before you begin.
- With the engine off and cooled, place a drain pan beneath the oil pan and remove the drain bolt to drain used oil (catch and dispose of it properly).
- Remove the old oil filter using an appropriate filter wrench, taking care not to spill oil.
- Lightly coat the gasket on the new filter with fresh engine oil to ensure a proper seal.
- Install the new filter by hand until it seats, then tighten according to the filter’s instructions (usually about 3/4 to 1 full turn after the gasket contacts the mounting surface).
- Replace the drain plug, wipe any spills, and refill with the recommended oil capacity for your engine (approximately 4.5 quarts for the 1.8L; check exact spec in the owner’s manual).
- Run the engine a few minutes, then shut off, wait for oil to settle, and check the level and for leaks.
Note: Some Honda filters use a slightly different mounting orientation or gasket size depending on market; always verify with your vehicle’s specifics and torque requirements.
Summary
In short, for the common 2013 Honda Civic with the 1.8L engine, use Honda Genuine Oil Filter 15410-PLM-A01; for the 2.4L Civic Si, use 15410-PRB-A01. Always confirm with your VIN or official parts catalog to avoid misidentification, and follow proper replacement steps to maintain engine health.