The 2008 Honda Fit uses a standard spin-on oil filter; the OEM part most commonly cited is 15410-PLM-A02.
About the 2008 Fit's oil filter
The Fit’s 1.5-liter i-VTEC engine relies on a spin-on oil filter that threads into the engine block. When replacing it, you can use Honda’s Genuine part or a reputable aftermarket filter, as long as it matches the engine’s thread size and gasket diameter. Part numbers can vary slightly by production batch, so it’s a good idea to compare the replacement filter to the one you’re removing or to consult the owner’s manual for the exact specification.
Replacement options
Shop options fall into two broad categories: OEM Honda filters and aftermarket equivalents that explicitly state compatibility with the 1.5L Fit. Either route is acceptable if the product is designed for a 2007–2009 Honda Fit with a 1.5L engine.
- OEM Honda oil filter: 15410-PLM-A02 (spin-on). This is the official Honda replacement for many 2007–2009 Fits with the 1.5L engine.
- Alternative OEM revisions: Some production runs use 15410-PLM-A01; they are typically interchangeable with the same engine family and vehicle year range. Verify by comparing the current filter to the replacement.
- Aftermarket filters: Choose brands that specify compatibility with Honda 1.5L Fits (and note the same thread size and gasket diameter). Reputable examples include Wix, Bosch, Mann, and Fram; always double-check the product listing for your exact year/model.
Concluding: If in doubt, go with the Genuine Honda filter to guarantee fit and filtration performance, and ensure you purchase a filter with the correct thread size and gasket. Also replace the drain plug gasket if applicable and follow proper torque recommendations during installation.
How to replace the oil filter on a 2008 Honda Fit
Steps: Warm the engine to operating temperature; drain old oil; remove the old filter with an oil filter wrench; smear a light coat of new oil on the gasket of the new filter; install by hand until snug, then give it a half-turn (or as specified in the service manual); refill with the correct amount of oil and check for leaks.
Summary
For a 2008 Honda Fit, the oil filter is a spin-on unit, most commonly the Honda Genuine part 15410-PLM-A02. You can use this OEM filter or select a reputable aftermarket filter that lists compatibility with the 1.5L Fit, ensuring the correct thread size and gasket. Always verify your specific vehicle’s needs by checking the existing filter or consulting the owner’s manual.