The 2004 Honda CR‑V mainly uses a 2.4-liter engine, and the correct oil filter is the Honda Genuine filter matched to that engine. For most U.S. 2004 CR‑Vs, the filter is Honda Genuine 15410-PLM-A02. In markets that used a 2.0-liter engine, the compatible filter is 15410-PLM-A01. Always verify with your VIN or by checking the existing filter if you’re unsure.
Engine options and filter fitment
In 2004, the CR‑V was produced with different engines depending on the market. The United States and many regions relied on the 2.4‑liter K24A engine, which requires a specific filter, while some export variants used a smaller 2.0‑liter engine. Because filter design is tied to engine size, using the correct part number ensures proper fit and filtration.
OEM oil filter part numbers
Two common Honda Genuine oil filter part numbers are used across 2004 CR‑V configurations, depending on engine size. Below are the numbers to look for when ordering from a dealer or selecting a replacement:
- For the 2.4L engine (most 2004 US CR‑Vs): Honda Genuine Oil Filter 15410-PLM-A02.
- For the 2.0L engine (certain export models): Honda Genuine Oil Filter 15410-PLM-A01.
These part numbers reflect typical factory catalogs. If your vehicle's engine size is different due to regional specifications, confirm with a Honda dealer or by checking the existing filter's model number.
Aftermarket compatibility and cross-reference guidelines
If you prefer aftermarket filters, ensure the replacement will physically fit the housing and matches the engine’s thread size, gasket type, and anti-drainback valve requirements. Use filters that explicitly state compatibility with the Honda CR‑V 2.4L or with Honda engines of that generation. When in doubt, consult the product's cross-reference guide or your local parts counter.
In practice, popular aftermarket choices will state compatibility with Honda 2.4L CR‑V models, but always verify by checking the thread size (typically 3/4-16) and whether the filter has an anti-drainback valve suitable for a cold-start environment.
Conclusion: Use a Honda Genuine filter for certainty on fit, or verify aftermarket options with a cross-reference and the vehicle's exact engine size.
Installation tips for replacing the oil filter
When replacing the oil filter, follow these practical steps to ensure a proper seal and clean operation:
- Warm the engine to operating temperature so oil flows more easily.
- Turn off the engine, lift the vehicle if necessary, and place a drain pan beneath the filter.
- Carefully remove the old oil filter, allowing oil to drain out; inspect the old filter for any unusual debris.
- Lightly oil the gasket on the new filter with fresh engine oil.
- Install the new filter by hand until snug, then tighten about three-quarters of a turn further (do not overtighten).
- Replace the oil drain plug gasket if needed, refill with the recommended oil quantity and type, and check for leaks.
Conclusion: Proper installation ensures the new filter seats correctly and prevents leaks during operation.
Additional notes and recommendations
Always follow the owner’s manual for oil grade and capacity. For a 2004 CR‑V, Honda typically recommends 5W-20 (with 5W-30 in hotter climates or certain driving conditions), and the oil capacity is generally around the 4.5 quart/4.3 liter range with a filter change. Using the correct filter is an important part of preserving engine health and meeting maintenance requirements.
Summary
In short, the 2004 Honda CR‑V uses a Honda Genuine oil filter matched to its engine size: 2.4L engines use 15410-PLM-A02, while 2.0L variants use 15410-PLM-A01. Verify with the dealer via VIN or by inspecting the current filter if you’re unsure. For aftermarket options, ensure compatibility by engine size and fitment features such as thread size and anti-drainback valves, and follow proper installation practices to maintain engine longevity.