Most Chrysler 200 models use 5W-20 full synthetic motor oil. Some engines or model years may allow 0W-20 or synthetic blends, but you should verify the exact specification for your car in the owner’s manual or under-hood label.
The Chrysler 200 was offered with two main engines during its production run (2011–2017): a 2.4-liter Tigershark inline-four and a 3.6-liter Pentastar V6. Oil requirements vary by engine and year, so this guide outlines the typical recommendations and how to confirm them for your specific vehicle.
Oil types by engine
Below are the common recommendations by engine for the Chrysler 200. Use only the viscosity and specification listed for your year and engine.
- 2.4L Tigershark inline-four: Typically calls for 5W-20 synthetic motor oil or a synthetic blend, meeting current API SN or newer. Use a reputable motor oil that meets Chrysler/MOPAR specs or an equivalent.
- 3.6L Pentastar V6: Typically calls for 5W-20 full-synthetic motor oil that meets API SN and ILSAC GF-5 (MOPAR-approved or equivalent).
Note: Some model years or climates may have alternative acceptable viscosities (for example, 0W-20) as allowed by the manual. Always confirm with your specific manual or dealer based on your VIN.
How to maintain and change the oil
When it’s time for an oil change, follow these steps to ensure accuracy and proper lubrication:
- Warm up the engine briefly and park on a level surface.
- Turn off the engine and apply the parking brake; if needed, raise the vehicle for access.
- Drain the old oil by removing the drain plug and allow it to completely drain into a suitable container.
- Remove and replace the oil filter with a new one designed for your engine.
- Install the drain plug, add the correct amount and grade of oil through the oil fill cap, and replace the cap.
- Check the oil level with the dipstick, add more if necessary in small increments, start the engine, and check for leaks.
- Dispose of used oil and filter responsibly and reset maintenance indicators as needed.
Following these steps helps ensure that your engine remains properly lubricated and protected between service intervals. If you drive in extreme conditions (very hot/cold climates, frequent towing), consult your dealer for any special considerations.
Summary
For most Chrysler 200 models, the standard oil is 5W-20, with a synthetic or synthetic-blend formulation. Engine choice (2.4L Tigershark or 3.6L Pentastar) determines the exact specification, but both generally require a modern API SN (or newer) and often ILSAC GF-5. Always check the owner’s manual or the under-hood label for the precise viscosity and specification for your year and VIN, and use a Mopar-approved oil or equivalent. Regular oil changes with the correct oil help maintain performance and fuel efficiency for the Chrysler 200.