In most cases, the 4.7 L V8 engine (2UZ-FE) typically takes 5W-30 motor oil, with full-synthetic recommended and an oil capacity of roughly 7 to 8 quarts.
The 4Runner lineup in the United States did not commonly offer a 4.7 L engine; the 4.7 L V8 is associated with other Toyota/Lexus models such as LX470 and some Land Cruiser variants. Engine oil specifications can vary by year and market, so it’s essential to check your owner’s manual, the under-hood sticker, or the manufacturer’s service portal for your exact configuration.
Typical oil type and grade for the 4.7 L 2UZ-FE
Here is a concise guide to the most common oil options for the 4.7 L V8 used in this family of vehicles.
Viscosity and oil type options
The standard recommendation is 5W-30 engine oil, preferably full synthetic. Conventional 5W-30 is acceptable if synthetic is unavailable, but synthetic oil is preferred for protection and longer change intervals. In very hot climates or with very high-mileage engines, some drivers use 10W-30, but you should avoid heavier or off-spec oils unless the manual specifically allows it.
- 5W-30 full synthetic (preferred)
- 5W-30 conventional (acceptable if synthetic unavailable)
- 10W-30 (hot climates or very high-temperature operation, if approved by manual)
- Avoid heavier grades such as 20W-50 unless explicitly directed by the manual
For best results, use oil that meets current API standards (such as SN or newer) and ILSAC GF-5 or GF-6, depending on availability and the vehicle’s requirements.
Standards and compatibility
Always verify that the oil you select meets or exceeds the engine’s requirements as stated in your owner's manual, and prefer oils labeled for gasoline engines with the proper API/ILSAC ratings and OEM approvals when shown.
Oil capacity and change intervals
Knowing how much oil your engine holds and when to change it helps prevent under- or over-filling and keeps the vehicle running smoothly.
- Oil capacity with filter: roughly 7.0 to 7.5 quarts (varies by model and drain procedure)
- Conventional oil change interval: about 3,000 to 5,000 miles
- Synthetic oil change interval: about 7,500 to 10,000 miles
- Severe service or towing: shorten intervals accordingly
- Always confirm dipstick level after refilling to reach the correct mark
These ranges are typical for the 2UZ-FE engine family. Exact capacity and interval figures can vary by year, market, and whether the engine is the 2UZ-FE variant in your vehicle. Refer to the owner’s manual or dealer guidance for precise figures.
Model-specific notes and verification
Because the 4.7 L option has been used primarily in non-U.S. markets and in related models, it’s essential to confirm your exact engine and specification before purchasing oil. The 4Runner in the U.S. rarely used the 4.7 L engine, while the 2UZ-FE was common in LX470 and Land Cruiser variants.
To ensure you’re using the correct oil, check the VIN, the hood placard, and the official owner’s manual or Toyota’s online service portal for your exact configuration.
Summary
For the 4.7 L V8 variants that powered some 4Runners and related Toyota/Lexus models, the typical oil choice is 5W-30, preferably full synthetic, with about 7 to 8 quarts capacity. Always verify with the exact manual for your year and market, ensure the oil meets API/ILSAC standards, and adhere to the recommended change intervals, adjusting for driving conditions and towing if applicable.