The 2020 Honda Fit EX uses SAE 0W-20 full-synthetic engine oil. The engine’s capacity is roughly 3.7 quarts with a filter, and you should verify the exact specification in the owner’s manual or on the under-hood sticker for your market.
With a 1.5-liter four-cylinder engine, Honda designed the Fit EX to run efficiently on a light, low-viscosity oil. The recommended oil should be synthetic and meet API SN or higher, ideally matching Honda’s own specification. This helps optimize fuel economy and engine longevity.
Oil type and viscosity
The Fit EX is designed to run on a high-quality 0W-20 oil, balancing performance and protection for daily driving and fuel efficiency.
Why 0W-20 matters
The 0W-20 grade provides better cold-start protection and fuel economy while meeting modern emission and wear-performance standards for the Fit’s compact engine.
- Viscosity: SAE 0W-20
- Oil type: full-synthetic (or a high-quality synthetic blend that meets API SN or higher)
- Certification: API SN or higher; compatible with Honda’s specification
In brief, use 0W-20 full-synthetic that meets the API SN or higher and Honda’s specification for the 2020 Fit EX.
Capacity and service intervals
Engine oil capacity and how often you should change it are standard parts of routine maintenance. For the Fit EX, the system is designed around a small, efficient four-cylinder engine that benefits from a consistent supply of clean oil.
- Oil capacity (with filter): approximately 3.7 quarts (3.5 liters)
- Recommended service interval: about every 7,500 miles (12,000 km) under normal driving
- Severe driving conditions: more frequent changes may be advised
Always confirm with the owner’s manual or dealer literature for your exact market, as capacity and intervals can vary slightly by region or model year.
How to check and top up oil safely
Here are basic steps to check the oil level and add oil if needed. Following these steps helps ensure you maintain the correct level and avoid overfilling.
- Park on level ground and turn off the engine; allow it to cool if recently driven.
- Open the hood and locate the dipstick; pull it out, wipe clean, reinsert, and pull out again to check the level.
- If the level is below the minimum mark, add small amounts of 0W-20 oil a little at a time, then recheck.
- Repeat until the dipstick reads within the proper range, then run the engine for a minute and recheck again after turning it off.
Tip: If you’re unsure, consult the owner's manual or have a professional perform an oil change to ensure correct capacity and filter replacement.
Where to buy and how to verify the oil you use
Buy oil that matches the exact specification for your vehicle. Look for 0W-20 full synthetic with API SN or higher, and consider Honda Genuine or reputable brands that meet the specification. Always verify the grade and API rating on the label or the product data sheet.
- Use 0W-20 full synthetic that meets API SN or higher
- Prefer Honda Genuine oil or equivalent from top-tier brands
- Check the owner's manual for region-specific recommendations
With the right oil, the Fit EX can maintain optimum performance, efficiency, and longevity through its service life.
Summary
The 2020 Honda Fit EX takes SAE 0W-20 full-synthetic motor oil, usually in a capacity of about 3.7 quarts with a filter. Use oil that meets API SN or higher and Honda’s specified standards, and follow the recommended service intervals in the owner’s manual. Regular checks help ensure the engine runs smoothly and efficiently.