The short answer: it uses 0W-20 full-synthetic motor oil.
For the 2016 Odyssey, Honda specifies 0W-20 as the recommended viscosity for the 3.5-liter V6 engine. This viscosity is chosen to balance cold-start protection, fuel efficiency, and long-term engine cleanliness. While 0W-20 is standard, always verify the exact requirement in your owner’s manual or with a Honda dealer if your driving conditions or regional specifications differ.
Oil type and capacity for the 2016 Odyssey
Key specs at a glance for this model are listed below.
- Viscosity: 0W-20
- Lubricant type: full-synthetic motor oil (recommended)
- Oil capacity: approximately 4.5 quarts with a filter change
- Specifications: ILSAC GF-5 or newer; API SN or newer
- Maintenance interval: typically every 7,500 miles or 12 months under normal driving; more frequent under severe conditions
Adhering to these specifications helps ensure proper lubrication, fuel economy, and engine protection over the Odyssey’s lifespan.
How to check and change the oil
If you’re performing an oil change yourself or simply checking the level, these general steps apply. This is not a substitute for the service manual.
- Warm up the engine briefly, then park on level ground and turn off the engine.
- Allow the oil to settle, then place a drain pan beneath the oil pan and remove the drain plug to drain the old oil.
- Remove and replace the oil filter with a new one of the correct specification.
- Reinstall the drain plug, then add about 4.5 quarts of 0W-20 oil using a funnel to avoid spills.
- Start the engine, run for a minute, then turn off and check the oil level with the dipstick, adding more as needed to reach the full mark.
- Reset the oil life/maintenance minder if your vehicle has it, and dispose of used oil responsibly.
Always consult the owner's manual for model-year-specific steps or torque values for the drain plug and filter, and use a filter recommended by Honda or your chosen oil brand.
FAQ: Can I use a different viscosity like 5W-20?
The official specification for the 2016 Odyssey is 0W-20. Using a different viscosity can affect lubrication performance and warranty coverage. If you cannot obtain 0W-20, contact your dealer or Honda customer service before proceeding.
Summary
In summary, the 2016 Honda Odyssey takes 0W-20 full-synthetic motor oil, with an approximate capacity of 4.5 quarts per change, and a typical replacement interval of about 7,500 miles under normal driving. Always verify the exact requirements in your owner's manual and follow Honda's maintenance guidance to keep the engine running smoothly.