The 2016 Honda CR-V requires 0W-20 synthetic engine oil (API SN or newer) for its 2.4-liter engine, with an approximate fill of 4.7 quarts. Typical oil changes are recommended about every 7,500 miles under normal driving. Always verify the exact specification on your vehicle’s oil cap or in the owner’s manual.
Official oil specification and climate considerations
Honda specifies 0W-20 synthetic engine oil that meets the API SN standard (or newer) as the standard for the 2016 CR-V’s 2.4L engine. This viscosity supports fuel efficiency and reliable cold-start performance in a range of climates. While the grade is generally consistent, always check your owner’s manual for any region-specific notes or updates.
Viscosity and API grade
Primary requirement: 0W-20 viscosity that meets API SN or a newer specification. Using a high-quality full-synthetic 0W-20 oil helps ensure optimal lubrication and performance for this engine.
Capacity and maintenance intervals
Below is a quick reference for the oil capacity and change intervals you should follow for normal driving conditions. In severe-driving situations (extremely hot or cold climates, frequent short trips, heavy loads, or towing), expect shorter intervals.
- Viscosity: 0W-20
- Oil type: Synthetic oil
- API grade: SN or newer
- Oil capacity: Approximately 4.7 quarts (with filter)
- Oil-change interval: Normally about 7,500 miles or 12 months, whichever comes first; in severe service, around 3,750 miles or 6 months
Sticking to these specifications helps protect engine wear, maintain performance, and support warranty terms. Always confirm the exact capacity and intervals in your owner’s manual, as variations can occur by market or trim level.
Practical guidance for owners
To ensure you meet the spec consistently, use a reputable full-synthetic 0W-20 oil that carries the current API certification mark, and replace the oil filter at each change. If you’re unsure about the right grade for your climate or plan to operate in extreme conditions, consult your dealer or the owner's manual for confirmation.
Summary
For the 2016 CR-V’s 2.4L engine, the recommended oil is 0W-20 synthetic meeting API SN or newer, with a typical capacity of about 4.7 quarts and an oil-change interval of roughly 7,500 miles under normal driving. Verify the exact specification in your owner’s manual or on the oil cap, especially if you’re in a region with unusual climate or driving conditions.