The 2016 Honda Accord uses 0W-20 full synthetic engine oil. The typical capacity is about 4.5 quarts for the 2.4-liter four-cylinder and about 5.7 quarts for the 3.5-liter V6, with the oil meeting API SN or newer and ILSAC GF-5 specifications. Use Honda Genuine Motor Oil or an equivalent that satisfies these specs, and always verify with your owner’s manual or the oil filler cap.
Oil type and capacity by engine
The following details apply to the two engine options offered in the 2016 Accord. Each section lists the recommended viscosity, oil type, and typical capacity, along with specification guidance.
2.4-liter inline-four engine
Below are the specifications for the 2.4L engine most commonly found in the 2016 Accord lineup.
- Viscosity: 0W-20
- Oil type: Full-synthetic motor oil
- Capacity (with filter): about 4.5 quarts (approx. 4.3 L)
- Specifications: API SN or newer; ILSAC GF-5; Honda-approved or equivalent meeting these specs
- Notes: Use Honda Genuine Motor Oil or an equivalent that meets these standards
Concluding note: For the 2.4L engine, plan for roughly 4.5 quarts when performing a drain and fill with a new filter, and recheck the oil level after adding any required top-off.
3.5-liter V6 engine
Details for the 3.5L V6 option, which appears in higher-end trims of the 2016 Accord, are as follows.
- Viscosity: 0W-20
- Oil type: Full-synthetic motor oil
- Capacity (with filter): about 5.7 quarts (approx. 5.4 L)
- Specifications: API SN or newer; ILSAC GF-5; Honda-approved or equivalent meeting these specs
- Notes: Use Honda Genuine Motor Oil or an equivalent that meets these standards
Concluding note: For the V6 version, ensure you have about 5.7 quarts of oil when performing a drain and fill with a new filter, then verify the level and top off as needed.
General maintenance tips
After selecting the correct oil, follow the maintenance schedule in your owner’s manual. Synthetic 0W-20 oil typically supports longer change intervals under normal driving, commonly around 7,500 miles, with more frequent changes under severe driving conditions. Always check the dipstick after adding oil and reset the service reminder as appropriate.
Summary
The 2016 Honda Accord generally requires 0W-20 full synthetic oil across its engine options. Expect about 4.5 quarts for the 2.4L engine and about 5.7 quarts for the 3.5L V6, with oil meeting API SN or newer and ILSAC GF-5 specifications. Use Honda Genuine Motor Oil or an equivalent that satisfies these standards, and confirm exact specs in your owner’s manual or on the oil filler cap for your specific trim.