The 2010 Honda Fit typically requires SAE 5W-20 engine oil, API SN or newer, with an oil capacity of about 3.7 quarts (3.5 liters) including the filter. Use oil that meets Honda’s specifications, such as Honda Genuine Oil or any brand that matches these standards. Check the owner’s manual for your exact model and climate conditions.
Oil specification
Understanding the exact oil specification helps ensure proper lubrication and engine protection for daily driving. Below are the key points you should verify when selecting oil for a 2010 Fit.
- Viscosity: 5W-20
- API service rating: SN or newer
- ILSAC rating: GF-5 or newer
- Capacity: approximately 3.7 quarts (3.5 liters) with filter
- Oil type: Conventional or synthetic that meets the above specifications
Following these specifications helps maintain engine performance and reliability across typical driving conditions. Always confirm the exact requirements in the owner’s manual or with a Honda dealer, since regional variations can occur.
Climate and service considerations
Climate and driving habits can influence the oil choice and change frequency. While 5W-20 is the standard recommendation for most climates, extreme temperatures or severe service may warrant consulting the manual or a dealership for any climate-specific guidance.
Climate guidance
In very hot environments or where the car undergoes frequent severe service (short trips, heavy loads), synthetic oil can offer advantages, but the fundamental specification remains 5W-20 with SN or newer. Always prioritize the official recommendations for your market.
Maintenance steps for an oil change
If you’re planning an oil change, follow these steps to ensure you use the correct oil and perform the procedure safely and effectively.
- Verify the oil grade (5W-20) and API/SN or newer certification before purchase
- Drain the old oil after warming the engine slightly to help drainage
- Replace the oil filter with a new unit
- Refill with about 3.7 quarts of oil, then check the level with the dipstick
- Run the engine, recheck for leaks, and recheck the oil level once the engine cools
Using the correct oil and performing a proper oil change helps protect the engine and sustain fuel efficiency. If you’re unsure about performing the change yourself, a qualified technician can handle it to specification.
Summary
The 2010 Honda Fit uses 5W-20 engine oil, API SN or newer, with an approximate capacity of 3.7 quarts (3.5 liters) including the filter. Both conventional and synthetic oils that meet these specifications are acceptable. Always verify the exact requirements in the owner's manual or with a dealer, especially if you live in extreme climates or follow Honda’s maintenance minder recommendations. Regular oil changes are essential to maintaining engine health over the vehicle’s lifespan.