The standard oil for a 2007 Jeep Commander with the 4.7-liter V8 is 5W-30 engine oil, and you can use conventional or synthetic oil that meets the vehicle’s specifications.
In more detail, the 4.7 L V8 typically requires a viscosity of 5W-30 as the default, suitable for a wide range of operating conditions. Oil used in this engine should meet API service classifications and the Chrysler MS-6395 specification. Both conventional and synthetic oils are acceptable as long as they conform to these standards. Climate and driving conditions can influence the best choice, but 5W-30 is the recommended starting point for most setups—always verify with the owner's manual for your exact vehicle and region.
Recommended oil specifications
Use the following quick reference to verify you’re selecting the correct oil when servicing the engine. The list covers viscosity, oil type, and standards to look for on the label.
- Viscosity: 5W-30 is the primary recommendation for the 4.7 L V8 in the 2007 Commander. In some very hot climates, 10W-30 is an option, but 5W-30 remains the standard choice.
- Oil type: Conventional oil, synthetic blend, or full synthetic are all acceptable, depending on your preference and budget, as long as the oil meets the required standards.
- Standards: The oil should meet API service classifications appropriate for gasoline engines (such as API SM/SL or newer) and Chrysler MS-6395 specification.
- Oil change considerations: Follow the owner's manual for recommended intervals and consider driving conditions (city vs. highway, short trips, and climate) when choosing between conventional and synthetic oils.
Concluding: For the 4.7 L V8 in the 2007 Commander, choose a 5W-30 oil that meets API service requirements and the Chrysler MS-6395 specification. Either conventional or synthetic oil is acceptable; climate and your driving style may influence your final choice. Always refer to the owner's manual for the exact specification and maintenance intervals.
Summary
In brief, the 2007 Jeep Commander’s 4.7 V8 uses 5W-30 engine oil that must meet API service standards and Chrysler MS-6395. You can use conventional or synthetic oil; check the manual for climate-specific guidance and precise maintenance intervals.
What oil does a 4.7-liter V8 take?
SAE 5W-30
Engine Oil
5W-30 (Below 38°C) - SAE 5W-30 is preferred. Capacity: 6 quarts (with filter).
What kind of oil does a Jeep Commander V8 take?
5W-20
Mobil 1 – Extended Performance 5W-20 High Mileage Full Synthetic Motor Oil, Prevents Leaks, 1 Quart (Part No. 15017)
How many quarts of oil does a 2007 Jeep Commander 4.7 take?
Oil Grade: API*
| Viscosity: | 5W-20 (All TEMPS) |
|---|---|
| Capacity: | 6 quarts (with filter). After refill check oil level. |
| Torque: | 25 ft/lbs (Oil Drain Plug) |
How much is a 2007 Jeep Commander worth today?
Estimated Private Party Values range from about $3,250 to $5,125 depending on vehicle style. Values and prices are based on national averages and typical mileage for this model, but they can vary greatly according to mileage, condition, location, and other factors. Valid through 4/13/2026.