In most US-spec 2013 Honda CR-Vs, the low-beam headlight bulb is H11, the high-beam bulb is 9005 (HB3), and the fog lights, where equipped, use H11. However, bulb sizes can vary by trim level and international market, so it’s wise to verify by checking your owner’s manual or the bulb itself before purchasing.
Overview of the 2013 CR-V headlight setup
The 2013 Honda CR-V traditionally uses a split-headlamp setup with separate bulbs for low beams, high beams, and fog lights on most trims. While the common US configuration relies on halogen bulbs, some markets or aftermarket upgrades can differ. Always confirm the exact bulb type for your vehicle by inspecting the bulb base or consulting the official manual for your specific trim and market.
Low-beam bulbs
Low beams illuminate the road at night and in poor weather. The vast majority of 2013 CR-Vs in the United States use a single low-beam bulb per side, and the typical specification is as follows:
- H11 — the standard low-beam bulb for most US-spec 2013 CR-Vs
- 9006 — a less common alternative in some overseas trims or special headlamp assemblies
In practice, H11 is the standard choice for the low beams on the 2013 CR-V, with 9006 appearing only in certain regional variants or aftermarket setups. Always verify before purchasing a replacement.
High-beam bulbs
High beams are separate from the low beams and are used for long-range signaling on open highways. The typical high-beam bulb for the 2013 CR-V is:
- 9005 (HB3) — standard high-beam bulb for most CR-V trims
Some markets or headlamp assemblies may differ, but 9005 is the common factory specification for the high beams in the 2013 model year.
Fog light bulbs
Fog lights, when equipped, are designed to cut through fog and mist at lower speeds. For many 2013 CR-V configurations, the fog lights use:
- H11 — the typical fog-light bulb for CR-V models that have factory fogs
If your vehicle doesn’t have factory fog lights, this section may not apply. Always confirm by inspecting the fog-light housing or checking the manual for your exact trim.
How to confirm and replace safely
To ensure you buy the correct bulbs and replace them safely, follow these steps:
- Check your owner’s manual or a model-specific guide for your exact trim and market to confirm bulb sizes.
- Inspect the existing bulb by removing the headlight/DLC cover to read the bulb type stamped on the base.
- Purchase the correct type (e.g., H11 for low beam, 9005 for high beam, H11 for fog lights if equipped) from a reputable brand.
- Wear gloves or use a clean tissue when handling bulbs to avoid oil contamination, which can shorten bulb life.
- Replace one bulb at a time to avoid mixing different types in the same circuit, unless you are sure the other side is the same type.
- Test the lights after installation in a safe environment before driving at night.
If you are unsure about the bulb type, consult a dealership or a trusted automotive technician who can verify the exact specification for your VIN and market.
Summary
The 2013 Honda CR-V most commonly uses H11 for low beams, 9005 for high beams, and H11 for fog lights when equipped. Variations can occur by trim level or international market, so always confirm with the owner’s manual or by inspecting the actual bulb base. Proper replacement and handling will ensure optimal visibility and bulb longevity.