The part number for the oil filter on the 2013 Acura TL’s 3.5L V6 is Honda/Acura part 15400-PLM-A02.
In 2013 the TL uses a 3.5-liter V6 from Honda’s J-series family. The engine uses a standard spin-on oil filter designed for that family. Manufacturers and parts databases list 15400-PLM-A02 as the official Honda/Acura filter for the J-series-based TL of this era. While aftermarket filters may fit, using the exact OEM part helps ensure proper seating, gasket compatibility and warranty coverage.
Official part number and model guidance
The 3.5L V6 TL commonly uses the Honda/Acura oil filter part number 15400-PLM-A02. This part is widely cited for vehicles powered by the J-series 3.5L engine, including the 2013 TL. Always confirm with your VIN or a dealer/parts database if you are unsure about regional variations.
Replacement steps (basic guide)
Below is a general guide for replacing an oil filter on a typical 3.5L TL. Use the vehicle’s service manual for exact procedures and torque specs.
- Warm up the engine, then safely lift and support the vehicle. Place a drain pan beneath the oil filter and drain plug.
- Remove the old filter using a filter wrench if needed; be prepared for oil spillage.
- Apply a light coat of new oil to the gasket on the new filter, install by hand until snug, then give it an additional 3/4 turn (or per filter’s instructions).
- Replace the drain plug, refill engine oil to the correct level, start the engine, and check for leaks. Reset maintenance light if applicable.
If you’re not comfortable performing this service, have a professional technician handle the oil change to ensure proper installation and avoid leaks or cross-threading.
Aftermarket considerations
There are aftermarket filters that fit the 3.5L V6 in the TL. When shopping, look for filters labeled as compatible with Honda/Acura 3.5L engines and verify the thread size and gasket diameter match your filter housing. If in doubt, refer to the dealer or a trusted parts retailer using your VIN to confirm compatibility.
Summary
For a 2013 Acura TL with the 3.5L V6, the official oil filter part number is 15400-PLM-A02. Using the exact OEM part is recommended for proper fit, seal, and filtration, though many aftermarket options exist that are compatible when correctly matched. Always verify with the dealer, parts catalog, or your VIN if you’re unsure.