The oil filter number most commonly used on the 2013 Honda Fit with the 1.5-liter engine is Honda Genuine Part 15400-PLM-A02.
This article explains the standard part number, how to confirm it for your vehicle, and practical tips for replacement. The 2013 Fit in many markets uses a 1.5L engine with a cartridge-style oil filter, but there are variations by market and model revision. Always verify the exact part number against your VIN and the official parts diagrams.
Part number and compatibility
Honda’s typical OEM oil filter for the North American 2013 Fit equipped with the 1.5L engine (L-series) is 15400-PLM-A02. Depending on market, revision, or engine variant, other numbers such as 15400-PLM-A01 or 15400-PLM-A03 may apply. Verification against your vehicle’s VIN is the safest way to ensure the correct part.
Notes on variations
Variations can occur for non-U.S. models or later revisions of the Fit. If your car differs from the standard North American 2013 spec, consult the dealer or the official Honda Parts Catalog to confirm the exact filter number for your engine code.
How to verify the correct filter for your car
Before buying a replacement, follow these steps to verify you have the correct oil filter part number:
- Gather your vehicle’s exact engine code and model year from the VIN or owner's manual.
- Consult the official Honda Parts Catalog or your dealership’s parts counter for the part number matched to your VIN.
- Inspect the existing filter or its packaging for the part number before purchasing a replacement.
- When in doubt, ask a dealer or reputable parts retailer to cross-reference using your VIN to ensure a proper fit.
Following these steps helps ensure you purchase the correct cartridge-style filter and avoid fitment issues during installation.
Where to buy and replacement tips
You can purchase the OEM filter from Honda dealers or authorized parts retailers. Aftermarket equivalents are available, but compatibility can vary. If you’re replacing the filter yourself, remember to also replace the O-ring on the filter housing, lubricate the gasket with fresh oil, and follow the service manual’s torque specification for the drain plug and housing.
Practical replacement tips: use a new O-ring, clean the housing, apply a thin film of fresh oil to the O-ring, thread the filter housing by hand to seat, then snug it according to the manual. Dispose of used oil and filter responsibly.
Summary
For a 2013 Honda Fit, the typical oil filter part number is 15400-PLM-A02, though variations can occur by market or revision. Always confirm with your VIN and official parts diagrams or a dealer. This approach helps ensure you install the correct cartridge-style filter and maintain proper engine lubrication.
What oil filter does a 2013 Honda Fit use?
15400-PLM-A02) Genuine Honda original equipment oil filter for your Honda vehicle. Engineered and specified by Honda, this is the same filter as that which would be installed by your dealer.
What does the PH7317 oil filter fit?
Broad Compatibility: The PH7317 filter fits a wide range of Honda, Subaru, Nissan, and Acura vehicles from 2001 to 2023.
What type of oil does a 2013 Honda Fit take?
Mobil 1 – High Mileage 0W-20 Full Synthetic Motor Oil, Extends Engine Life, 5 Quart (Part No. 15015)
What is the part number of the Honda oil filter?
15400-PLM-A02
Genuine Honda Oil Filter - 15400-PLM-A02.