In most markets the correct oil filter number for a 2010 Honda Accord depends on which engine your car uses. The 2010 Accord was offered with two engines: a 2.4-liter inline-4 and a 3.5-liter V6. The typical OEM part numbers used by Honda for these engines are 15400-PLM-A01 for the 2.4L and 15410-RAA-A01 for the 3.5L. Always confirm with your vehicle’s VIN or a current parts diagram, as regional variations can apply.
Engine options in the 2010 Accord
The oil filter you need is tied to the engine specification rather than the model year alone. This article highlights the two common configurations for the 2010 Accord and the corresponding OEM filter numbers.
Two engine options
Here are the most commonly used OEM oil filter numbers by engine type.
- 2.4-liter inline-4 engine: Honda part number 15400-PLM-A01
- 3.5-liter V6 engine: Honda part number 15410-RAA-A01
Note: These part numbers are typical for U.S. and many global markets but can vary by region. Always verify with your VIN or the official Honda parts diagram for your exact vehicle.
How to verify the correct filter
To ensure you purchase the exact match for your car, use one of these verification steps before ordering:
- Check the owner’s manual or the maintenance section for the recommended oil filter part number corresponding to your engine.
- Inspect the oil filter currently installed on the car and compare its packaging or part number to the official diagram for your VIN.
- Use Honda’s official parts lookup by VIN (or consult a Honda dealer parts department) to confirm the exact filter for your engine code and region.
- If buying aftermarket, choose a filter specifically labeled as fitting the 2010 Accord’s 2.4L or 3.5L engine, and verify compatibility with your year and trim.
Verifying the exact part number helps avoid mismatches that can arise from regional catalog differences or minor engine code updates.
Summary: For a 2010 Honda Accord, the oil filter number varies by engine. Common OEM numbers are 15400-PLM-A01 for the 2.4L and 15410-RAA-A01 for the 3.5L. Always double-check via VIN-based parts lookup or the dealer to be certain.
Where is the oil filter on a 2010 Honda Accord V6?
Now looking underneath the car. If you go underneath the front of the car here you'll see in the back on the right. Side is where the uh the oil filter is located that's your wheel on the right. Side.
What size oil filter for 2010 Honda Accord?
4L L4 Gas Oil Filter.
What is the part number of the Honda oil filter?
15400-PLM-A02
Genuine Honda Oil Filter - 15400-PLM-A02.
What kind of oil does a 2010 Honda Accord take?
5W-20
What type of oil does an 2010 Honda Accord take? Use the manufacturer-recommended viscosity and specification; for the 2.4L engine this is typically 5W-20, but confirm in your owner's manual.