The lug nuts for a 2019 Honda Civic Type R are M12x1.5 with a 60-degree conical seat and a 19mm hex.
For context, the 2019 Civic Type R (FK8) uses five lug nuts per wheel and relies on proper seating to maintain wheel integrity at high speeds. This article breaks down the exact nut size and seating to help you source correct replacements and verify compatibility when rotating tires or upgrading wheels.
Key lug nut specifications
Before you buy or replace lug hardware, it's important to know the official measurements and compatibility. The Type R uses a standard five-lug setup, but the securing nuts themselves have specific sizing you must match. The details below summarize the essential measurements you’ll need when sourcing replacements.
- Thread size: M12x1.5 (12 mm diameter, 1.5 mm thread pitch)
- Seat type: 60-degree conical (tapered) seat
- Socket size: 19 mm hex
- Number of nuts per wheel: 5
- Compatibility note: Use lug nuts that match the seat type and thread pitch of your wheels; aftermarket wheels should specify 12x1.5 with a 60-degree conical seat for Honda FK8
With the right nuts, install carefully to ensure proper seating and avoid damage to studs or wheels during tire changes and high-performance driving.
How to verify on your vehicle
To confirm the exact lug hardware on your Civic Type R, check the wheel spec sheet, owner’s manual, or the packaging of any aftermarket wheels you plan to use. Look for notes on thread pitch, seat type, and recommended socket size. If in doubt, consult a Honda service technician or a trusted tire shop to verify compatibility and avoid fitment issues.
Summary
The 2019 Honda Civic Type R uses five M12x1.5 lug nuts with a 60-degree conical seat and a 19mm hex socket. This specification is standard for the FK8’s wheels; always verify seat type and thread pitch when swapping wheels or sourcing replacement hardware to ensure a correct and safe fit.