The 2008 Honda CR-V uses a 5-lug wheel pattern with standard lug nut dimensions: lug studs are M12 x 1.5, the lug nuts have a 19 mm hex head, and the wheel hub has a 64.1 mm center bore. In practical terms, you’ll typically need OEM-style lug nuts for the factory wheels and a 19 mm socket to tighten them to about 80 ft-lb (108 Nm). This guidance applies to stock wheels; aftermarket wheels can vary and may require different lug nuts or hub rings.
Wheel bolt pattern and hub compatibility
Understanding the vehicle’s wheel interface helps ensure proper fitment and safe driving. Here are the key compatibility details you should know.
- Five-lug pattern: 5 lug bolts on a 114.3 mm (4.5 inches) bolt circle (5x114.3).
- Center bore: 64.1 mm, which helps center OEM wheels on the hub.
- Hub-centric vs. lug-centric: OEM wheels are typically hub-centric; aftermarket wheels may require hub rings if center bore mismatches occur.
Conclusion: Verifying the bolt pattern and center bore is essential for safe wheel installation and proper alignment.
Lug nut size, seating, and torque
Knowing the lug nut specifics ensures you install wheels correctly and avoid damage to studs or wheels. The CR-V uses common hardware that fits most stock and many aftermarket rims.
- Thread size: M12 x 1.5 pitch on the wheel studs.
- Lug nut seat: 60-degree conical seating is typical for OEM Honda wheels.
- Hex size: 19 mm (socket size) is standard for tightening lug nuts on this vehicle.
- Torque: tighten to approximately 80 ft-lb (108 Nm) in a star pattern; always confirm with the owner's manual or the door jamb sticker for your exact spec.
Conclusion: Use the correct lug nuts and torque to ensure even clamping and long-term reliability.
Center bore and wheel-fit considerations
Center bore compatibility affects vibration and wheel balance. If you’re upgrading to aftermarket wheels, pay attention to hub alignment and potential need for rings.
- Center bore: 64.1 mm; ensures proper centering on the hub for OEM wheels.
- Hub rings: may be required for aftermarket wheels with a larger center bore to achieve proper hub centering.
- Offset and backspacing: verify compatibility with the CR-V’s suspension and wheel well clearance.
Conclusion: Center bore accuracy matters for smooth operation; consult wheel specs and consider hub rings if using aftermarket rims.
Practical guidance for CR-V owners
When buying wheels or lug nuts, confirm the exact specifications for your 2008 CR-V’s trim and wheel size. If in doubt, consult a dealership or a qualified tire shop, and share your VIN and wheel details. For aftermarket wheels, ensure correct lug pattern, seat type, center bore, and torque to maintain safety and performance.
Summary: For a 2008 Honda CR-V, the standard bolt-related specifications are a 5x114.3 mm lug pattern, M12 x 1.5 wheel studs, lug nuts with a 19 mm hex head and 60-degree seating, a center bore of 64.1 mm, and a typical lug nut torque of about 80 ft-lb (108 Nm). Always verify against your specific wheel configuration and refer to the owner’s manual or manufacturer guidelines for exact figures.