The tire pressure button resets or recalibrates the Tire Pressure Monitoring System (TPMS) so it can relearn tire sensor data after tires are inflated or replaced. It does not pump air or measure tire pressure itself.
How the Tire Pressure Monitoring System works
The Civic’s TPMS uses sensors in each wheel to monitor air pressure and, in some cases, temperature. If any tire drops below the recommended level, a warning light on the instrument cluster illuminates and stays on until the issue is resolved. The system continuously tracks sensor IDs and pressures, and a reset is typically needed only after servicing tires or changing tire sizes.
Using the tire pressure button to reset or recalibrate
Resetting the TPMS helps the system relearn the correct sensor data and the proper cold pressures after you inflate or replace tires. The exact procedure can vary by trim, but the general steps below apply to many 2016 Civics.
To reset the TPMS, follow these steps:
- Ensure all four tires are cold and inflated to the recommended cold pressures shown on the driver’s door jamb sticker.
- Turn the ignition to ON with the engine off and locate the TPMS (Tire Pressure) reset button on the lower left side of the dash near the steering column (look for a button labeled TPMS or Tire Pressure).
- Press and hold the button until the TPMS indicator on the dash blinks or a confirmation message appears, then release.
- Drive at speeds above about 30 mph (50 km/h) for 10–20 minutes to allow the system to relearn each sensor’s data. The warning light should turn off when relearn is complete.
- If the warning light remains on after attempting a reset, recheck the tire pressures and consider having tire sensors or wheels inspected for faults.
Note: In some trims or under certain conditions, the TPMS may relearn automatically when tires are inflated to the correct pressures, without pressing the reset button.
When to seek help
If the TPMS warning does not clear after a reset, or you notice erratic readings, consult a Honda dealer or a qualified technician. Faulty sensors, damaged wheel valves, or a dead sensor battery can prevent proper monitoring and require service.
Summary
The tire pressure button on a 2016 Honda Civic is designed to reset or recalibrate the Tire Pressure Monitoring System after tires are inflated, rotated, or replaced. It helps the system relearn sensor data and ensure accurate warnings. Always inflate tires to the recommended pressures first, perform the reset if needed, and drive to complete the relearn. If warnings persist, seek professional assistance.
Does tire pressure affect TPMS?
What is the difference between TPMS and proper tire pressure? Essentially, TPMS is a warning system that alerts you when your tire is 25 percent above or below the recommended pressure. Low tire pressure is one of the mechanical conditions it warns you about.
Where is the TPMS button located?
Process will begin if there's no button the procedure is done with the display audio. Begin by pressing the home. Button then touch settings touch vehicle next and then TPMS calibration.
How to turn off tire pressure low on Honda Civic 2016?
Step the calibration process will finish automatically. Within a few miles of driving. See your vehicle's owner's manual for more details or go to owners.honda.com.
How to see tire pressure on a 2019 Honda Accord?
Pressure we need to know what the correct pressure should be For that open the driver's. Side door and right over there the tire pressure label which states that for this tire. Size the cold tire.