The Honda Odyssey uses a 5-lug bolt pattern: 5x114.3 mm (5 by 4.5 inches).
Bolt pattern basics
Bolt pattern describes how many lug holes a wheel has and the diameter of the circle those holes form. For the Odyssey, that pattern is five lug holes on a 114.3 mm circle. When shopping for wheels or tires, it’s not just the lug count you need to match—the center bore and offset matter as well to ensure proper fitment and hub alignment.
Does the Odyssey use 5x114.3?
Yes. The vast majority of Honda Odyssey models produced in recent years use a 5x114.3 mm bolt pattern. While this is the standard, it’s always wise to verify for your exact model year and market, since rare exceptions can occur. The typical center bore for Honda vehicles is 64.1 mm, which many aftermarket wheels with 5x114.3 mm bolt patterns will accommodate.
How to verify your specific vehicle
Before using the list below, check your exact model year and trim to confirm the bolt pattern, since exceptions can exist for certain markets or early generations.
- Consult the owner's manual or the tire/wheel specification section for your vehicle.
- Inspect the current wheels and count the lug nuts, then measure the bolt circle by extending a straight line across the wheel hub from lug hole to lug hole.
- Look up the official spec for your exact VIN on Honda’s parts or service site.
- Check the wheel center bore requirement (usually 64.1 mm for Hondas) to ensure proper hub centering.
- When in doubt, contact a Honda dealership or a trusted tire/wheel shop to confirm compatibility.
Following these steps will help you confirm whether a wheel will fit your Odyssey without adapters or modifications.
Edge cases and variations
While 5x114.3 mm is standard for most Odysseys, very early-generation models or region-specific variants could differ. If you own a vehicle outside the common US market, or an unusually early year, check the precise specification for your VIN to avoid mistakes.
Summary
For most Honda Odyssey owners, the bolt pattern is 5x114.3 mm (five lug holes on a 114.3 mm bolt circle). Always verify with your exact model year and market using the owner’s manual, VIN-based Honda spec tools, or a qualified wheel professional to ensure proper fitment and safety.