No. The 2019 Jeep Compass uses a single 12‑volt starting battery. It does not have a second high‑voltage or auxiliary battery in standard trims.
This article explains the battery configuration, where the battery is located, and what to expect when inspecting or replacing the battery on a 2019 Compass.
Battery configuration in the 2019 Jeep Compass
Key facts about the battery layout for the 2019 Compass are summarized below.
- The vehicle uses a single conventional 12‑volt lead‑acid battery to start the engine and power typical electrical systems (lights, infotainment, ECU, sensors).
- There is no separate high‑voltage or auxiliary battery in the standard 2019 Compass configuration, as it was not offered as a hybrid or plug‑in hybrid in that model year.
- Location is typically in the engine bay, on the driver’s side, connected to the alternator and starter motor.
- Battery replacement follows the usual procedure for small SUVs, including checking the charger/alternator function and ensuring the terminals are clean and tight.
In short, the 2019 Compass uses a single 12‑volt battery; there is no dual‑battery setup in stock forms.
Summary
For the 2019 Jeep Compass, there is no dual‑battery configuration. A single 12‑volt battery handles starting and most electrical loads. If you see references to two batteries, they are likely due to aftermarket modifications or non‑standard variants outside the 2019 US market.