To reset the tire pressure monitoring system (TPMS) on a 2019 Honda Pilot, first bring all tires to the recommended cold pressures, then recalibrate the TPMS using the vehicle’s learning/relearn feature or a dedicated reset button if your model is equipped with one, and finally drive at highway speeds to complete the relearn.
Understanding TPMS on the 2019 Honda Pilot
The TPMS is designed to warn you when a tire is underinflated. After inflating tires or rotating/replacing tires, the system may need to relearn the new tire pressures. Availability of a TPMS relearn option and its exact location can vary by trim level and market, so consult your owner’s manual if you’re unsure.
Option A: Relearn via the TPMS menu (recommended, if supported)
Many 2019 Pilots offer a TPMS relearn/calibration option in the vehicle’s settings. This method guides the system through a formal relearn without using a physical button.
- Inflate all tires to the recommended cold pressures listed on the driver-side door jamb placard.
- Turn the ignition to ON and ensure the engine is not running.
- On the display screen, navigate to Settings or Vehicle, then find TPMS and select Learn/Relearn or Calibrate.
- Confirm the choice and wait for a confirmation message on the screen.
- Drive at highway speeds (about 50 mph or more) for at least 10 minutes, or until the TPMS warning light stops blinking and stays out.
Note: If your vehicle does not show a Learn/Relearn option in the menus, this method may not be available on your trim. In that case, use the other method below or consult the manual for your exact build.
Option B: Use a TPMS reset button (if equipped)
Some Pilot trims place a dedicated TPMS reset button somewhere in the cabin (often under the dash or near the glove box). If your model has this button, follow these steps.
- Inflate all tires to the recommended cold pressures shown on the door placard.
- Turn the ignition to ON with the engine off.
- Locate and press/hold the TPMS reset button for 3–5 seconds until the TPMS indicator in the instrument cluster blinks or a confirmation message appears.
- Release the button and drive the vehicle at highway speeds for about 10–15 minutes to complete the relearn.
If the TPMS light remains on after attempting the reset, recheck tire pressures and try the relearn process again. If the light continues to illuminate, there may be a faulty sensor or other tire issue requiring service.
Extra tips for a reliable reset
Always verify tires are cold and inflated to the exact pressures shown on the placard before starting the relearn. If you’ve recently rotated tires, replaced a wheel, or repaired a tire, a relearn is often necessary to synchronize the sensors with the new setup.
In some cases, simply driving normally for a few miles after inflating to the correct pressures will allow the TPMS to relearn automatically, especially if the system is not showing any warning lights. If you’re uncertain, refer to your owner’s manual for the exact procedure for your trim level and regional market.
What to do if the TPMS light stays on
If the TPMS warning light remains after attempting a relearn, confirm all tires are at the correct pressures (including the spare, if your model monitors it) and reattempt the relearn. If problems persist, there may be a sensor failure or low battery in a sensor, which would require diagnosis at a Honda service center.
Summary
Resetting TPMS on the 2019 Honda Pilot involves inflating tires to the correct cold pressures, performing a relearn via the vehicle’s TPMS menu or a dedicated reset button if equipped, and driving at highway speeds to complete the process. If the warning persists, consult the owner’s manual for your exact trim or seek licensed service to check sensor integrity.