Inflating all tires to the recommended cold pressures and performing a relearn—either automatically by highway driving or manually with a TPMS reset option—will typically reset the tire pressure warning light on Honda models. The exact steps vary by year and trim, so check your owner's manual for model-specific instructions.
Understanding TPMS and why the light comes on
The Tire Pressure Monitoring System (TPMS) monitors each tire’s air pressure and alerts you when any tire falls below the recommended level. A slow leak, seasonal temperature changes, or new tires can trigger the warning. After tires are inflated to the correct pressures, most Hondas relearn the system either automatically or via a manual reset, and the light should turn off once the system recognizes normal pressure again.
Reset options you may encounter on Honda models
Before attempting the steps, ensure all tires are cold and inflated to the vehicle’s recommended cold pressures found on the driver's door jamb or in the owner's manual. The following options cover the most common Honda approaches.
- Automatic relearn via highway driving: After inflating all tires to the recommended pressures, drive at about 50 mph (80 km/h) or higher for roughly 10 minutes. The TPMS should relearn the new pressures and the light will go out.
- Manual reset using a TPMS button (if your model is equipped): With the ignition in the ON position and the engine off, locate the TPMS/SET button (often near the left side of the dash). Press and hold it until the TPMS indicator blinks or goes out, then release. Drive to complete the relearn.
- Manual relearn via instrument cluster or settings (some models): Access TPMS settings from the instrument cluster or information display, select “Calibrate” or “Relearn,” and follow prompts. Then drive at highway speeds for the specified time to finalize the relearn.
Note: The exact button, location, and sequence can vary by model and year. If you don’t find a TPMS button or your vehicle doesn’t respond to these steps, consult your manual or contact a Honda dealer for model-specific guidance.
Manual TPMS reset button method
For Honda models that include a dedicated TPMS/SET button, the standard approach is to turn the ignition to ON (engine off), press and hold the button until the TPMS indicator blinks or sounds a chime, then release. After that, drive on a highway at a steady speed to complete the relearn.
Automatic relearn by driving
Many Hondas relearn automatically after inflating tires to the correct pressures. A highway drive at a sustained speed helps the system register the new pressures and turn off the warning light once the relearn is complete.
Troubleshooting if the light stays on
If the TPMS light remains on after you've inflated the tires and attempted a relearn, check for:
- A slow leak or puncture in any tire
- A faulty TPMS sensor or damaged valve stem
- Recent tire rotation or replacement that may require a manual relearn
If you suspect a sensor fault or cannot complete a relearn, visiting a mechanic or Honda service center is recommended for a diagnostic and potential sensor replacement.
After tire service or replacement
When tires are replaced or rotated, a TPMS relearn is often required. Some Honda dealers perform the relearn automatically, while others require you to perform the steps described above. Always verify the light is out after the service before driving extensively.
Summary
To reset the tire pressure light on a Honda: inflate all tires to the proper cold pressures, then use the appropriate relearn method for your model—automatic highway driving or a manual reset button if equipped. If the light persists, inspect for leaks or faulty sensors, and seek professional service if needed. Regular TPMS maintenance helps ensure accurate readings and safer driving.