To reset the TPMS on a 2016 Honda Civic, inflate all tires to the vehicle’s recommended cold pressures shown on the door jamb placard, then use the TPMS reset procedure and drive to relearn. If the warning light remains after these steps, seek service to check sensors or leaks.
Understanding TPMS and when a reset is needed
The Tire Pressure Monitoring System (TPMS) alerts you when one or more tires are underinflated. A reset is often required after inflating tires, rotating tires, or changing wheels or sensors. Resetting tells the system what the current, correct pressures are so it can monitor accurately again.
Before you reset: set the tires to the correct pressure
Make sure every tire is inflated to its recommended cold pressure, as listed on the driver’s door placard. Do not use the maximum pressure printed on the tire sidewall. Check all four tires (and the spare if your model uses a sensor on the spare) to ensure a consistent baseline before resetting.
- Check each tire’s pressure with a reliable gauge when the tires are cold.
- Inflate all tires to the recommended cold pressures shown on the door jamb placard.
- Inspect tires for obvious leaks, punctures, or damage and repair as needed before proceeding.
With the tires properly inflated, you’re ready to perform the TPMS reset procedure.
Reset procedure for the 2016 Civic
These steps cover the typical TPMS reset method used on many 2016 Civics with direct TPMS. If your trim differs, refer to the owner’s manual or contact Honda support for your particular configuration.
- Turn the ignition to ON with the engine OFF (do not start the car).
- Locate the TPMS reset button. It is usually under the dash on the left side of the steering column or near the glove box; look for a button labeled with a tire pressure symbol.
- Press and hold the TPMS reset button until the TPMS indicator on the dash blinks or a confirmation message appears. This may require several seconds of holding.
- Release the button and wait for the indicator to finish blinking or for the confirmation to disappear.
- Drive the vehicle at speeds above about 30–50 mph (50–80 km/h) for 10–20 minutes to relearn the new pressures. Avoid stopping or restarting during this relearn period if possible.
The TPMS light should turn off after a successful relearn. If it stays on, recheck tire pressures and retry, or have the system checked by a professional.
Troubleshooting if the light stays on or cannot reset
If the warning persists after following the reset procedure, several issues could be at play, including sensor problems, slow leaks, or a need for reprogramming after tire changes. Proceed with these checks before seeking service:
- Re-check all tire pressures, including the spare if equipped with a sensor, to confirm they are at the correct cold pressures.
- Inspect tires for slow leaks or damaged valves and repair or replace as needed.
- If a tire was recently replaced or sensors were changed, the system may require professional relearning with a scan tool.
- Consider having a service technician scan the system for faulty sensors or a faulty TPMS module, especially if the light remains on after a proper relearn.
Note: Some situations—such as replacing all tires or wheels—may require sensor programming by a dealer or qualified shop.
Summary: The 2016 Honda Civic’s TPMS can be reset by inflating all tires to the door-plug pressures and using the TPMS reset button, followed by driving to relearn. If the warning persists, verify pressures again and seek professional inspection to check sensors or leaks.
Where is the TPMS reset button on a 2016 Honda Civic?
From what I understand we go to settings. We go to vehicle. And right up there TPMS calibration so then we go to calibrate. That clears it. So now as we go drive.
How to Calibrate Honda Civic 2016 tire pressure?
Step the calibration. Process will finish automatically within a few miles of driving. See your vehicle's owner's manual for more details or go to owners.honda.com for a downloadable.
Why is my tire pressure light still on after filling tires on my Honda Civic 2016?
The TPMS, or Tire Pressure Monitoring System, on your Honda's dashboard can be frustrating. Even after checking and adjusting your tire pressure as the manual suggests, the warning light might stay on. This can happen for several reasons, like changes in temperature or if the tires were not installed correctly.
How do I reset the tire pressure in a Honda Civic?
Wait for the options to come up. Press the home button. And go to Whoops Daisy settings third one down. And then we're going to go into vehicle this one here.


