The Tire Pressure Monitoring System (TPMS) on a 2010 Honda Accord can be reset by ensuring all tires are inflated to the recommended pressures, using a dedicated TPMS reset button if your model has one, or allowing the system to relearn automatically after you drive at highway speeds. The exact method depends on whether your car is equipped with a reset switch or relies on an automatic relearn.
Understanding TPMS in the 2010 Accord
TPMS monitors tire pressure and alerts you when a tire drops below the recommended level. In 2010 Accords, some trims include a dedicated reset button to retrain the system, while others rely on a built‑in automatic relearn once correct tire pressures are set and the vehicle is driven. Knowing which setup your car has will determine which steps you follow.
Preparation: Check Tire Pressures
Before attempting to reset, ensure all tires are inflated to the recommended pressures when cold. This is essential for an accurate reading and successful relearn. The vehicle’s door jamb label lists the correct front, rear, and spare pressures where applicable.
- Check all four tires with a reliable gauge and adjust to the specified cold pressures.
- Don’t forget to check the spare if your model uses a full‑size spare with a TPMS sensor.
- Inspect for punctures or slow leaks that could cause pressure changes.
With the tires properly inflated, you’re ready to choose the reset method that matches your car’s configuration.
Reset methods
Method A: Using a TPMS reset button (if equipped)
If your 2010 Accord includes a dedicated TPMS reset button, use these steps to retrain the system.
- Turn the ignition to ON (engine OFF).
- Ensure all tires are inflated to the recommended cold pressures.
- Locate the TPMS reset (Set/Reset) button, which is typically near the steering column, in the glove box, or on the lower dash.
- Press and hold the TPMS/reset button until the TPMS indicator light in the instrument cluster blinks or you hear a chime.
- Release the button and drive at highway speeds (about 50 mph / 80 km/h or higher) for at least 10 minutes to complete the relearn.
If the light remains on after this procedure, you may have a faulty sensor or wheel sensor calibration issue; a service visit could be required to diagnose or replace sensors.
Method B: Automatic relearn (no reset button) – just set pressures and drive
If your 2010 Accord does not have a TPMS reset button, the system typically relearns automatically after the tires are properly inflated and you drive under suitable speeds.
- Inflate all tires to the recommended cold pressures and re-check for accuracy.
- Start the engine and drive on highways at 50–65 mph (80–105 km/h) for 10–20 minutes, or vary driving to accumulate 20–30 minutes of active driving.
- Observe the TPMS light: in most cases, it will go off once the relearn completes. If it stays on, repeat the drive or consult a tire service shop.
Note that certain wheel configurations, sensor wear, or damaged valves can prevent a successful relearn; if issues persist after multiple attempts, seek professional assistance to test sensors and reprogram if needed.
What to do after a reset
After a successful reset or automatic relearn, maintain correct tire pressures and check them regularly. If you rotate tires, you may need to repeat the relearn procedure depending on sensor positioning and model specifics.
Summary
Resetting the TPMS on a 2010 Honda Accord depends on whether your model has a dedicated reset button or relies on automatic relearn. Start by inflating all tires to the recommended cold pressures, then follow the appropriate method or drive to calibrate. If problems persist, have the TPMS sensors tested by a dealer or tire professional.