Replacing the rear wiper blade on a 2017 Honda CR-V is a quick DIY task you can complete in minutes: lift the wiper arm, release and remove the old blade, snap on a new blade, and re-seat the arm on the glass to test the wipe. This guide covers the tools and steps you’ll need, plus tips to ensure a secure fit.
What you’ll need
Before you start, gather the right blade size and a couple of basic supplies so the replacement goes smoothly.
- 11-inch rear wiper blade compatible with 2017 CR-V
- Clean rag or alcohol wipe for the arm’s connector
- Optional: small flat-head screwdriver to help release a stubborn blade
Having the blade on hand and the arm accessible keeps the job quick and clean.
Step-by-step replacement
Proceed with these steps in order to safely remove the old blade and install the new one.
- Park the vehicle, turn off the ignition, and gently lift the rear wiper arm away from the glass until it stays at about a 90-degree angle.
- Locate the release mechanism at the blade connector. Press the release tab and slide the blade toward the end of the arm to disengage; if your blade uses a locking clip, press the clip and pull the blade off.
- Remove the old blade completely from the wiper arm.
- Prepare the new blade by confirming the correct orientation and removing any protective covers from the connector.
- Attach the new blade by aligning it with the arm’s connector and sliding it on until you hear or feel a click, indicating it’s securely locked.
- Lower the wiper arm back onto the glass and test the rear wiper from inside the vehicle to ensure smooth operation and full coverage.
If the new blade doesn’t lock securely or doesn’t wipe cleanly, recheck the release mechanism, confirm you have the correct blade size, and ensure there’s no debris on the arm or blade connectors.
Tips and precautions
Keep these tips in mind to avoid common problems and ensure a long service life for your rear blade.
- Wipe away any dirt or moisture from the wiper arm tip before installing the new blade to ensure a clean seat.
- Do not force the blade onto a misaligned arm; realign and try again to prevent damage.
- Check that the blade is fully engaged with a secure click and that the arm rests properly on the glass after lowering.
- Dispose of the old blade and follow local recycling guidelines for rubber and metal components.
With proper alignment and a snug fit, the rear wiper should clear the window evenly and operate reliably through rain and snow.
Summary
Replacing the rear wiper blade on a 2017 Honda CR-V is straightforward: confirm you need an 11-inch blade, lift the arm, release and remove the old blade, install the new blade with a locking click, and test the wipe. Regular checks ensure optimal visibility and blade life.
What size rear wiper blades for 2017 Honda CR-V?
12 inches long
When you need a 2017 Honda CR-V wiper blade the first thing you need to consider is the size, which should be 26 inches on the driver side and 17 inches on the passenger side. There's also a rear wiper blade that's 12 inches long.
Can I replace CRV wiper blades myself?
We're going to take our new wiper. Slide these bottom tabs in much easier on the other one cuz I'm looking into the sun. Now. Okay we got to get this tab on top of the wiper arm. And then it snaps in.
What is the lawsuit on the 2017 Honda CRV?
A class action lawsuit alleges that 2017–2019 Honda CR-V and 2016–2019 Honda Accord vehicles experience parasitic battery drain and eventually shut down. The parasitic draw allegedly causes vehicle stalling and failure of headlights, emergency hazard lights, alternators and important safety functions.
How to change rear wiper blade 2017 Honda CR-V?
Side as we twist. It's going to actually remove. Completely. So one more time I'll do it close up so here's one more angle see as we twist towards the passenger. Side it releases from this right here.