In short, you unlock the fuel door from inside the car using the interior release lever, then open the exterior door and twist off the gas cap to refuel.
Inside the cabin: releasing the fuel door
Follow these steps to unlock and release the fuel door from the driver’s area before you approach the outside of the vehicle.
- Locate the fuel-door release lever near the driver's left footwell or lower dash. It is labeled FUEL or shown with a gas-pump icon. Pull the lever toward you to release the latch; you should hear a click when it unlocks.
- If your model uses a button instead of a lever, press the FUEL button or switch. The door should release after you press it.
- With the door released, exit the vehicle and move to the driver’s side rear quarter panel to access the exterior fuel door.
Once the interior release has activated, the exterior fuel door should either pop open slightly or be ready for you to press on its edge to release the latch. If it does not, you may need to apply light pressure to the door’s edge to free a spring-loaded latch.
Outside the car: accessing the fuel cap and fueling
These steps cover opening the door and completing the fueling process once you’re at the exterior side of the car.
- Push on the exterior of the fuel door to pop it open fully; swing the door outward to reveal the fuel cap.
- Twist the gas cap counterclockwise to remove it. Keep the cap tether attached so you don’t lose it.
- Refuel, then replace the cap by turning it clockwise until you hear a click, and close the fuel door by pressing it until it latches shut.
Always ensure the fuel door is fully closed before driving away. If you have a capless fueling system (not typical for the 2012 Accord), follow the specific manufacturer directions for that setup.
Troubleshooting and tips
What to do if the interior release won’t work
If the interior lever or button fails to release the fuel door, first make sure the car is unlocked. You may still be able to access the door from the outside by gently pressing on the door’s edge to release a spring latch. If the latch remains stuck, avoid forcing it—contact a dealer or roadside assistance to prevent damage to the fuel door or filler neck.
Summary
Opening the gas tank on a 2012 Honda Accord is typically a two-step process: release the interior fuel door and then access the exterior fuel door to remove the cap and refuel. If the interior release doesn’t work, try the exterior method carefully and seek professional help if needed to avoid damage.
How to open a 2012 Honda Civic gas tank?
Turn off the engine. 2. Press the fuel fill door release button. The fuel fill door opens.
Where is the fuel tank release button?
Door simply engage either to unlock the gas tank. Door. If there's no lever or button pushing directly on the gas tank door so that it g ly presses inward might unlock. It.
Where is the button to open the gas tank on a Honda Accord?
So you can see it a little bit. Pull out the key. And do you see this right here do you see this right here. This right here if you push this lever.
How to open Honda gas tank from trunk?
Side. Left you push this button here and the trunk will open. There you go now for the gas. The cover for the gas cap there is no gas cap have to push.