The spare tire on a 2005 Honda Pilot is stored under the rear cargo floor and lowered with the built-in hoist using the supplied crank or tool. Pull it out once released and set it aside for changing a tire or transporting it.
In the 2005 Pilot, the spare is kept out of sight beneath the cargo floor in the rear of the vehicle. It’s held in place by a hoist cable and a center fastener, and you’ll need the spare-tire toolkit stored with the vehicle to operate the hoist. The process is straightforward but requires the correct tool to release and lower the tire safely.
Tools and equipment
Before you begin, make sure you have the spare-tire toolkit and any required crank or bolt remover from the tool bin in the cargo area. Using the proper tool helps you lower the spare smoothly without damage.
- Spare tire (stored under the cargo floor)
- Spare-tire tool kit (including the crank/handle)
- Gloves (optional but helpful)
- Flashlight (optional for visibility under the floor)
Having these items ready ensures a smooth, safe removal of the spare from its cradle.
Steps to remove the spare
Below is the sequence to free the spare from its floor cradle. If your vehicle has slightly different hardware, the principle remains the same: release the hoist and lower the tire to the floor, then pull it out.
- Park on a level surface, engage the parking brake, and turn off the engine.
- Open the rear hatch and lift out the cargo floor panel to reveal the spare and hoist mechanism.
- Remove any trim or cover that conceals the spare’s center area to access the fastener or crank hole.
- If there is a center fastener, insert the provided crank or tool into the hole and turn counterclockwise to release the spare from the hoist; continue until the tire lowers to the floor.
- If your Pilot uses a separate fastener, use the spare-tire tool to loosen and remove it, then lower the tire using the hoist.
- Carefully pull the spare tire out from under the floor and place it on the ground.
- Close the floor panel and return tools to their storage location.
With the spare freed from its cradle, you’re ready to use it for a tire change or transport it as needed. Check the spare’s pressure and condition before driving far on it.
Safety and care considerations
Temporary spares are intended for short-term use and typically have speed limitations. Always follow the tire sidewall rating and the vehicle’s manual guidance. Re-seal and store the floor panel and tools securely after you finish to prevent rattling during driving.
Summary
To remove the spare tire from a 2005 Honda Pilot, access the cargo floor, locate the spare and its hoist, and use the appropriate crank or center fastener to lower the tire to the floor. Pull the tire out, inspect it, and then reinstall or replace it as needed. Keep tools organized in the cargo area and follow safety guidelines for temporary spares.
How to remove a 2005 Honda Pilot spare tire?
And here's the cable with a hammer you're going to have to tap this plate. Out. With this plate out you can jam it back through the hole. And pull the cable.
How to get a Honda spare tire out?
Off. So we'll do that that comes out make sure you don't lose that. And then all you have to do is pick up on the tire. And it comes out just like this. And just roll it out.
Where is the spare tire key for a Honda Pilot?
And while I can't promise you that the wheel lock key is going to be located. In the glove box of your Honda. Ultimately this is what you're looking for this bag. And let me show you what's. Inside.
How to release Honda Pilot spare?
Turn the wrench to the left to lower the spare tire to the ground.
- Keep turning the wheel nut wrench to create slack in the cable.
- Remove the bracket from the spare tire.