The information light on a 2015 Honda Civic is part of Honda’s Maintenance Minder system. It typically appears as a maintenance or oil-life indicator and is cleared after you service the car by resetting the maintenance display back to 100% oil life. This guide explains how to reset the light correctly and safely.
What the information light indicates
In the 2015 Civic, the information light usually corresponds to the Maintenance Minder and oil-life display. It signals when routine service is due, such as an oil change, tire rotation, or other periodic maintenance. If the light is on due to an actual fault, simply resetting it will not fix the underlying issue; you should perform the required service or address any indicated problems first.
Resetting the information light
Standard reset method for most trims
Use this method if your Civic shows the typical oil-life/MAINT display and has a trip/reset control on the instrument cluster.
- Locate the small SELECT/RESET knob near the instrument cluster (often used to cycle through the display screens).
- Press the knob to cycle to the Oil Life screen if it isn’t already showing.
- Press and hold the SELECT/RESET knob for about 5–10 seconds until the display changes and shows Oil Life 100% (or indicates the reset is complete).
- Release the knob, turn the ignition OFF, then start the engine to confirm the oil-life reads 100%.
Before you begin, make sure the ignition is ON (II) with the engine OFF. This ensures the display is active without actually starting the engine.
Resetting the maintenance Minder to 100% confirms the system is ready for the next service interval. If the display does not reset after several attempts, consult the owner’s manual or contact a Honda service center for guidance.
Alternative reset method for different display configurations
Some 2015 Civics with alternate instrument displays or trim differences may require a slightly different sequence. Use this approach if the standard method does not work on your specific cluster.
- Press and hold the SELECT/RESET knob for longer (about 10–15 seconds) until the display begins to blink or shows 100%.
- Release, then press and hold again for a few seconds until the screen confirms the reset. Turn the ignition OFF and then ON to verify the reading.
With the ignition ON (II) and engine OFF, ensure the display is showing the Oil Life screen. If not, repeatedly press the SELECT/RESET knob to reach it.
In some cases, the reset may require cycling the ignition off and on once more if the first attempt does not take. If you continue to encounter difficulties, refer to the owner’s manual for the exact sequence for your trim level or seek dealer assistance.
Tips and cautions
Always confirm that the underlying maintenance is completed before clearing the light. Resetting the display without performing required service can lead to neglect of important maintenance. If the light stays on or you notice warning messages after resetting, schedule a service appointment to diagnose potential issues.
Summary
The 2015 Honda Civic’s information light, part of the Maintenance Minder system, can be reset to 100% oil life by using the instrument cluster’s reset knob while the ignition is ON and the engine is OFF. Navigate to the Oil Life display, hold the reset control until the display resets, and verify by starting the car. If the standard reset doesn’t work on your model, try the alternative method or consult your manual or a dealer for precise instructions tailored to your trim.