Context: This report explains the expected transmission fluid capacity for the 2008 Honda CR-V with the 5-speed automatic transmission, including typical quantities for a full refill versus a standard drain-and-fill, and notes on using the recommended fluid and service procedures.
In general, a full transmission fluid refresh for the 2008 CR-V’s 5-speed automatic typically requires about 11 quarts of ATF.
The official amount can vary slightly depending on whether you drain the torque converter, replace the filter, or perform a machine flush vs. a manual drain-and-fill. Always verify with the vehicle’s service manual or a qualified technician for your specific VIN.
Capacity overview
Here are typical figures you might encounter when servicing this transmission. The exact amount depends on whether you perform a full replacement (pan removed and filter replaced) or a standard drain-and-fill (pan drain only).
- Full transmission fluid capacity with pan removed and filter replaced: about 11.0 to 11.5 quarts (approximately 10.4 to 11.0 liters).
- Conventional drain-and-fill (pan drain only, filter not replaced): typically about 5 to 7 quarts (approximately 4.8 to 6.6 liters).
These figures assume the use of the recommended ATF and service procedures, and that the engine is warm and the vehicle is on a level surface during the check and fill process.
Notes on accuracy
The exact amount can vary if the torque converter or cooling lines retain fluid, or if a fluid flush is used instead of a simple drain-and-fill. Refer to the Honda service manual for the precise quantity and procedure for your specific vehicle.
Fluid type and service recommendations
Honda specifies DW-1 automatic transmission fluid for the 2008 CR-V’s 5-speed automatic. Using the correct fluid helps ensure proper shifting, longevity, and warranty compliance.
- Use Honda DW-1 ATF unless your manual specifies an approved equivalent; avoid non-approved substitutes unless advised by a mechanic.
- Follow the official procedure for checking level and determining when the system is at the proper temperature and level, typically with the engine warm.
For exact steps, quantities, and any model-year nuances, consult the owner’s manual or a certified Honda technician who can tailor guidance to your vehicle’s VIN and transmission condition.
Summary
For a 2008 Honda CR-V with the 5-speed automatic transmission, plan roughly 11 quarts for a full drain-and-fill or about 5–7 quarts for a standard pan drain-and-fill. Use Honda DW-1 ATF and follow the manufacturer’s service procedures to achieve the correct level. When in doubt, have a professional complete the service to ensure accuracy and proper operation.