The 2013 Acura TL requires about 5 quarts of engine oil (roughly 4.7 liters) when performing a full oil change with the filter, using 5W-20 synthetic oil.
Official oil capacity and specifications
Before listing the capacity details, it’s important to note that the TL’s oil capacity accounts for a new oil filter being installed. The figures below reflect the standard specification for the 3.5L V6 used in the 2013 TL model range.
- Official oil capacity: 5.0 quarts (4.7 liters) with oil filter
- Recommended oil type: 5W-20 full synthetic
- Engine: 3.5L V6 (J35Z2)
- Applicable to all 2013 TL trims, including SH-AWD variants
When performing an oil change, plan to have the full 5.0 quarts on hand and follow the manufacturer’s specification to replace the oil filter as part of the service.
Choosing the right oil and maintenance tips
Below are practical guidelines to ensure you maintain proper lubrication and engine health for the TL’s 3.5L V6, including the recommended oil grade and routine checks.
- Use 5W-20 synthetic oil as specified for optimal protection and fuel efficiency.
- Replace the oil filter during every oil change to maintain filtration efficiency.
- Check the oil level with the dipstick after filling and recheck once the engine has run and settled.
- Dispose of used oil and filters in accordance with local regulations and recycling programs.
These steps help ensure the engine remains properly lubricated and reduces the risk of underfill or overfill complications.
Additional considerations
Not all 2013 TLs are exactly the same in every market, but in North American models the 5.0-quart capacity with a 5W-20 synthetic oil is the standard guidance from Acura for the 3.5L V6. If you’re ever unsure, consult your owner’s manual or the service bulletin for your vehicle’s exact configuration.
Summary: For a 2013 Acura TL, plan on about 5 quarts (4.7 liters) of 5W-20 synthetic oil per oil change, with a new filter. This specification applies across the TL lineup, so after draining and replacing the filter, you should reach the full-mark on the dipstick when refilling. Always verify with the dipstick and follow Acura’s recommendations for maintenance intervals.
How much oil does a 3.6 L V6 take?
Engine Oil
5.9 quarts (with filter).
How much oil does a 2013 Acura TL take?
5.0 quarts
How much oil does a 2013 Acura TL need? The 3.5L V‑6 typically requires approximately 4.5–5.0 quarts of engine oil with a filter change; final fill is set to factory specifications.
What kind of oil does a 2013 Acura TL take?
If you own a TL between model years 2004-2014, your engine's recommended oil is 5W-20, a fully synthetic oil; if your Acura TL model is even older, from model years 1999-2003, the most versatile and safe oil to use in your engine is 5W-30 synthetic oil.
What type of oil does a 3.5 L V6 take?
2.7L & 3.5L EcoBoost V6: 5W-30 synthetic.