Approximately 4.5 quarts (about 4.3 liters) of engine oil are needed when changing the oil and replacing the filter on the common 2.4L Tigershark engine used in many 2019 Compass models. Always verify the exact requirement for your specific engine and VIN.
The 2019 Jeep Compass offered a couple of powertrains depending on market, including the 2.4L Tigershark inline-four and, in some regions, a smaller turbocharged 1.4L engine. Oil capacity can vary slightly by engine configuration and whether you replace the filter, so use these figures as guidelines and confirm with the vehicle’s manual or dealer if you’re unsure. The recommended oil type is synthetic 0W-20, and you should follow the service interval outlined in the owner’s manual, typically around every 6,000 miles under normal driving conditions.
Oil capacity by engine variant
Note: Engine configurations vary by market and trim. The following figures reflect typical capacities for major 2019 Compass powertrains.
- 2.4L Tigershark I-4 engine: about 4.5 quarts (4.3 liters) of engine oil with a full-synthetic oil change that includes a new filter.
- 1.4L turbocharged engine (where available in some regions): about 4.0 quarts (3.8 liters) of engine oil with a filter.
Values can vary by exact engine configuration, so consult the owner’s manual or the VIN-specific spec plate if you’re unsure.
Oil type and service intervals
Below are guidelines for the type of oil to use and how often to change it.
- Oil type: Use synthetic 0W-20 high-quality engine oil as recommended by Jeep for most Compass engines and climates. Some regions may permit 5W-20, but 0W-20 is standard for the 2.4L Tigershark.
- Change intervals: Typical maintenance intervals are about every 6,000 miles (10,000 km) under normal driving, or up to 7,500 miles (12,700 km) if you’re using full synthetic and drive under favorable conditions. Always follow the owner’s manual for your exact interval.
- Top-up guidance: If you add oil between changes, do so in small increments (a quarter to a half quart at a time) and recheck the level with the dipstick to avoid overfilling.
Note: The above values are general guidelines and may differ by market, model year, and engine variant. Always confirm with the vehicle’s manual or the manufacturer.
Check and topping-up procedure
To ensure you maintain proper oil level and viscosity, use the following steps when checking and topping the oil between changes.
- Park on level ground and allow the engine to cool for at least 10-15 minutes after running.
- Remove the dipstick, wipe it clean, reinsert fully, and pull it out again to check the level against the marks.
- If the level is below the add mark, add oil gradually in small increments (¼ quart / ~0.25 L) and recheck the level.
- Do not overfill the engine; if you overfill, drain a small amount or wait for the oil to settle and revisit the level.
- Replace the dipstick, secure the oil fill cap, and run the engine for a minute, then recheck.
Regular checks help ensure the engine remains properly lubricated and performs reliably.
Summary: The 2019 Jeep Compass typically holds about 4.5 quarts of engine oil when you replace the filter, with capacity varying by engine variant. Use synthetic 0W-20, follow the manual’s service interval (commonly around every 6,000 miles), and always verify the exact spec for your VIN.