The 2010 RAM 1500 with a 5.7-liter Hemi V8 holds about 7 quarts of engine oil when you replace the oil filter during an oil change (roughly 6.6 liters). If the oil filter isn’t replaced, the capacity is closer to 6 quarts (about 5.7 liters).
Oil capacity details for the 5.7 L Hemi
These figures reflect standard maintenance practice and assume a full oil change with or without a new filter. The exact amount can vary slightly by engine variant and pan design, but the service manual lists the typical capacities below.
Common capacity figures
Before you begin a change, it’s useful to know the standard baselines for this engine:
- With a new oil filter: 7 quarts (approximately 6.6 liters).
- Without replacing the filter: about 6 quarts (approximately 5.7 liters).
These numbers serve as the practical guideline for most owners performing routine maintenance. When in doubt, always start with the higher figure (7 quarts) and adjust after checking the dipstick once the engine has run and cooled.
Guidance for oil changes
Plan around the standard capacity and follow a careful change procedure to ensure accuracy and engine protection.
- Warm the engine, then park on a level surface and gather a new filter and the correct oil quantity.
- Drain the old oil completely and remove the old filter; install a new filter with a light coating of fresh oil on the gasket.
- Fill with 7 quarts of the recommended oil, then run the engine for about a minute and inspect for leaks.
- Turn off the engine, wait several minutes, then recheck the dipstick and top off if necessary to reach the full mark.
In practice, use the dipstick as the final check after the engine has warmed up and run briefly, since oil expands with heat and the dipstick reading should reflect a full level when the oil has settled.
Oil grade and maintenance notes
For the 2010 RAM 1500 5.7 L, common practice is to use an engine oil in the 5W-20 to 5W-30 range, depending on climate and driving conditions. Always refer to the owner’s manual or a dealership for the exact viscosity specification for your region and usage patterns.
Summary
The 2010 RAM 1500 with a 5.7 L Hemi typically requires about 7 quarts (6.6 liters) of oil when you change the filter, and around 6 quarts (5.7 liters) if you don’t replace the filter. Use the dipstick to confirm the final level after an oil change, and adhere to the vehicle’s recommended oil grade for your climate and driving conditions.