Skip to Content
103 State St East Jordan, MI, 49727
  • MON: Closed
  • TUES: 8:00AM - 6:00PM
  • WED: 8:00AM - 6:00PM
  • THUR: 8:00AM - 6:00PM
  • FRI: 8:00AM - 6:00PM
  • SAT: Closed
  • SUN: Closed
MORE >
  • Yelp
  • Google Business Profile
  • Facebook
7984 North St Central Lake, MI, 49622
  • MON: 8:00AM - 6:00PM
  • TUES: 8:00AM - 6:00PM
  • WED: 8:00AM - 6:00PM
  • THUR: 8:00AM - 6:00PM
  • FRI: Closed
  • SAT: Closed
  • SUN: Closed
MORE >
  • Yelp
  • Google Business Profile
  • Facebook

How much oil does my 2022 Mitsubishi Outlander take?

For the 2022 Outlander’s primary gasoline engine, the engine oil capacity is about 4.8 quarts (4.5 liters) including the filter. This figure covers the common US-spec models, but exact capacity can vary by drivetrain and regional specifications.


The 2022 Outlander is offered in gasoline and plug-in hybrid (PHEV) variants. While the general oil-capacity figure is similar, you should verify the precise number for your exact model in the owner's manual or Mitsubishi service data since regional specs can differ.


Oil capacity by engine type


Below are the typical capacities used by the main 2022 Outlander configurations. Always confirm with your specific vehicle’s manual or service data.



  • Gasoline-powered Outlander (2.5L inline-4): approximately 4.7–4.8 quarts (4.5–4.6 liters) of engine oil, including the oil filter.

  • Outlander PHEV (2.0L hybrid setup): approximately 4.7–4.8 quarts (4.5–4.6 liters) of engine oil, including the oil filter.


Note: Some markets may list slightly different capacities (within about a tenth of a quart or so). Always use the service data for your specific VIN if precise accuracy is required.


How to check and change the oil


If you’re performing an oil change yourself, follow these general steps to ensure a proper refill and no leaks.



  1. Warm up the engine briefly to reach normal operating temperature, then park on a level surface and turn off the engine.

  2. Gather the right oil type and a new filter specified for the 2022 Outlander (commonly 0W-20 or as recommended in the manual).

  3. Lift the vehicle if needed and place a drain pan under the oil pan; remove the drain plug to drain old oil completely.

  4. Remove and replace the oil filter with a new one; reinstall the drain plug and tighten to the specified torque.

  5. Slowly add the correct amount of fresh oil through the oil fill cap, then replace the fill cap and start the engine to circulate oil for a minute.

  6. Turn off the engine, wait a few minutes, and check the oil level with the dipstick; add more oil in small increments if needed until the level is within the marked range.


After completing an oil change, inspect for leaks around the drain plug and filter. Dispose of used oil and filters at an appropriate recycling facility.


Oil-change intervals


Oil-change intervals vary by driving conditions, region, and oil type. For most drivers, the owner’s manual will specify an interval based on normal driving with synthetic oil, often in the range of every 7,500 miles (12,000 kilometers) or every 12 months, with shorter intervals for severe driving conditions. Always follow Mitsubishi’s official recommendations for your vehicle and oil specification to maintain warranty coverage and engine health.


Summary


The 2022 Mitsubishi Outlander typically takes about 4.8 quarts (4.5 liters) of engine oil, including the filter, though exact numbers can vary by variant and market. Gasoline and PHEV models are broadly similar in capacity, but always confirm with the owner’s manual or Mitsubishi service data for your specific vehicle. Regular oil changes with the correct oil type and filter help maintain engine performance and reliability.

Ryan's Auto Care

Ryan's Auto Care - East Jordan 103 State St East Jordan, MI 49727 231-222-2199
Ryan's Auto Care - Central Lake 7984 North St Central Lake, MI 49622 231-544-9894

Ask any car or truck owner in Central Michigan who they recommend. Chances are they will tell you Ryan's Auto Care.