The Acura TL Type-S uses about 5 quarts (roughly 4.7 liters) of engine oil with the filter installed. This article explains the official capacity, the recommended oil type, and practical tips for performing an oil change on this model.
Capacity, oil type, and specs
The TL Type-S is powered by a 3.2-liter V6 (J32A2) and shares the oil-fill characteristics common to the TL lineup of its era. For a full oil change, you can expect to need roughly 5 quarts of engine oil, with the oil filter replacement counted in. Always verify the exact specification in your owner's manual, as climate or driving conditions can influence the best oil choice and quantity.
Key specifications to know when servicing the TL Type-S:
- Engine: J32A2 3.2L V6
- Oil capacity: 5 quarts (4.7 L) with filter
- Recommended viscosity: 5W-30 (synthetic or synthetic blend preferred; check manual for climate-specific guidance)
- Oil filter: Replace with an OEM or high-quality equivalent
With the right parts and the correct quantity, the TL Type-S’s engine lubrication system will stay well protected under typical driving conditions. Always adhere to the manual for precise requirements and any year-specific notes.
DIY oil change steps
If you’re planning to change the oil yourself, here is a concise step-by-step guide to help you complete the job safely and effectively.
- Warm up the engine briefly to ensure the oil drains smoothly.
- Park on a level surface, engage the parking brake, and raise the front of the car if needed. Place a drain pan underneath the oil pan.
- Remove the engine oil drain plug and allow the oil to drain completely.
- Remove the old oil filter and replace it with a new filter, applying a light coat of oil to the gasket if recommended by the filter manufacturer.
- Reinstall the drain plug, then pour in about 5 quarts of the recommended oil. Use a funnel to avoid spills.
- Run the engine for a few minutes, then turn it off and check for leaks. Let the oil settle, then recheck the level with the dipstick and top up as needed to reach the correct level.
Following these steps helps ensure a proper oil change and accurate level measurement after the fill, reducing the risk of overfilling or underfilling.
Year-to-year notes
From 2004 through 2008, the TL Type-S generally follows the same oil capacity guideline of about 5 quarts with filter. Always consult the specific owner's manual for your model year and climate conditions to confirm the exact amount and viscosity recommendations.
Summary
For the Acura TL Type-S, plan on about 5 quarts (4.7 liters) of engine oil with a new filter, using a 5W-30 viscosity as a baseline. This guidance applies to the common 3.2L V6 variants used in the TL Type-S from the mid-2000s era. Always verify with your manual and use OEM-compatible filters and high-quality oil for best results.