The typical oil capacity for most U.S.-market Honda Odyssey models with the 3.5-liter V6 is 5.7 quarts of engine oil when performing a full change with a new filter, using 0W-20 synthetic oil. Always check your owner's manual for your exact year and market.
Understanding the oil capacity matters because it influences how much oil you need to buy, which grade to use, and when to perform changes. The Odyssey has spanned multiple generations, largely centered on the 3.5L V6 in North America, though market variations can alter exact figures and recommendations. This guide focuses on the standard capacity and common maintenance practices for most current U.S. models, with notes for non-U.S. variations.
Oil capacity and recommendations
Most U.S.-market Odyssey models sharing the 3.5 L V6 use the same specification for an oil change: 5.7 quarts of engine oil with a new filter, and 0W-20 synthetic oil is typically recommended. This applies across recent generations, though it’s always best to confirm in the manual if you have a non-standard market or edition.
Notes on variations
In non-U.S. markets or for certain trim levels, oil capacity or the recommended viscosity can differ. If your Odyssey is imported or from a different generation, consult the local owner’s manual or dealer guidance for the exact capacity and grade.
What you'll need for an oil change
Before you begin, gather the essential items to complete a standard oil change on an Odyssey.
- Engine oil: 0W-20 synthetic, quantity 5.7 quarts (with a new filter)
- Oil filter compatible with your Odyssey
- Oil filter wrench
- Funnel and rags
- Drain pan for used oil
- Socket set and jack stands or ramps
- New drain plug washer if needed
Having all the parts and tools on hand helps ensure a smoother change and accurate oil level when you’re done.
Step-by-step oil change (DIY)
To guide a DIY oil change, follow these steps. The procedure is standard for modern Odyssey models, but adapt if your engine layout differs or your service manual indicates variations.
- Warm up the engine briefly, then park on a level surface and turn off the engine.
- Raise the vehicle safely on ramps or stands and place a drain pan beneath the sump.
- Remove the drain plug and allow the old oil to drain completely; replace the drain plug with a new washer if needed.
- Remove the old oil filter and install a new one, lightly oiling the gasket on the new filter.
- Pour in 5.7 quarts of 0W-20 oil through a funnel, stopping periodically to check for spills.
- Check the oil level with the dipstick and add small amounts of oil as needed until the level is within the correct range.
- Start the engine, run briefly, look for leaks, then lower the vehicle and reset any oil-change indicator if applicable.
Dispose of used oil and the old filter at an approved recycling facility or auto-service station. Do not pour used oil down drains or onto the ground.
Summary
For most Honda Odyssey models sold in the United States, the engine oil capacity is 5.7 quarts with a new filter when using 0W-20 synthetic oil. Always consult your owner's manual for model-specific figures, especially if you’re dealing with a different market or generation. A careful, well-supplied DIY oil change includes gathering the right materials, following safe procedures, and disposing of waste oil responsibly.