The typical oil capacity for a 4.7 L V8 is about 5 quarts (roughly 4.7 liters) when changing the oil with a new filter. Always check your vehicle’s owner manual for the exact specification, as it can vary slightly by model and year.
The 4.7 L V8—often referred to as the PowerTech 4.7—was used in a range of Chrysler, Jeep, and Dodge models, most notably in the Jeep Grand Cherokee and Dodge Durango from the late 1990s into the early 2000s. While the standard capacity is generally consistent, slight variations can occur depending on the exact engine variant, optional equipment, and the size of the oil filter installed. The most reliable source for your exact figure is your vehicle’s owner’s manual or a dealership service bulletin for your specific year and model.
How to approach the oil fill during maintenance
When performing an oil change on this engine, plan on adding about 5 quarts of oil during the initial fill. After draining the old oil and replacing the filter, pour in a little less than the total amount, start the engine to circulate the oil, then recheck the dipstick and top off in small increments until the level reaches the full mark. Use the oil grade and viscosity recommended by the manufacturer for your climate and driving conditions.
Variants and practical considerations
Some configurations or aftermarket components can influence the exact fill level slightly. If your vehicle has an optional oil cooler, remote filter, or a different filter size, consult the service manual for your exact model and year to confirm the precise capacity. When in doubt, err on the side of the manual’s specification rather than relying solely on general figures.
Summary
For most 4.7 L PowerTech V8 engines, the standard oil capacity with a filter change is about 5 quarts (approximately 4.7 liters). Verify the exact figure for your year and model in the owner’s manual, and follow the dipstick readings to ensure proper oil level after a change. Regular oil changes help maintain performance and longevity for this engine family.