About 4.0 quarts (3.8 liters) of engine oil, including the oil filter, is sufficient for most 2.4L Frontier engines. Exact capacity can vary by engine code and model year, so always verify with your owner's manual or a trusted service manual for your VIN.
Over the years Nissan used a few different 2.4-liter variants in the Frontier, notably the QG24DE family. Oil capacity is listed in factory service data and can differ if your truck has an oil cooler, a different filter assembly, or other options. For the most accurate specification, check the exact engine code on the engine block or emissions label and consult the manual.
Engine variants and typical oil capacity
To help you plan your oil change, here is the typical capacity for the common 2.4L Frontier engine variant:
- QG24DE 2.4L engine (Frontier, earlier generation): oil capacity with filter ≈ 4.0 quarts (3.8 L).
Note: If your Frontier is equipped with an oil cooler or uses a different filter setup, the total capacity may be slightly higher. Always confirm with the factory data for your exact engine code and model year, and use the dipstick to verify the final oil level after a refill.
How to check and top up oil safely
Use these steps to perform an oil change and ensure the level is correct for a 2.4L Frontier engine.
- Warm up the engine, then turn it off and park on level ground.
- Place a drain pan underneath and remove the oil drain plug to drain the old oil completely.
- Remove the oil filter, replace it with a new one, and lubricate the new filter seal with a little oil before installation.
- Install the drain plug with a new washer and tighten to the manufacturer’s torque specification.
- Fill with the recommended oil amount of about 4.0 quarts (start with this amount if you’re unsure) and then check the level with the dipstick.
- Run the engine for a minute, turn it off, wait a few minutes, then recheck the oil level and add small amounts as needed until the dipstick shows the full mark.
Dispose of used oil and filters properly at a recycling facility or service center. If you’re unsure about the exact capacity for your vehicle’s engine code, consult the owner’s manual or a Nissan service bulletin for VIN-specific guidance.
VIN-specific guidance
Because the Frontier has used multiple 2.4L variants over its production span, the precise oil capacity can vary. Locate your engine code (often on the engine block or a label in the engine bay) and cross-check with Nissan’s official service data or your dealership to confirm the exact capacity for your truck.
Summary
For most 2.4L Nissan Frontier engines, plan to start with about 4.0 quarts (3.8 liters) of engine oil when changing the oil, including the filter. Exact capacity can differ by engine variant and optional equipment such as an oil cooler. Always verify with the owner’s manual or engine-specific service data, and confirm the final level with the dipstick after a refill.