The engine typically requires about 4.5 liters of oil for a full change with a new filter, and roughly 4.0 liters if you do not replace the filter. Exact figures can vary by model year and market.
This article provides the typical ranges for the 2.2 i-DTEC, explains why the numbers differ, and offers guidance on how to confirm the precise capacity for your specific vehicle.
Typical capacity ranges for the 2.2 i-DTEC
Oil capacity depends on whether the oil filter is changed and on the particular variant of the 2.2 i-DTEC installed in your Honda. The figures below reflect common guidance from service manuals and manufacturer specifications.
- With oil filter replaced: approximately 4.5 liters (commonly cited as about 4.3–4.6 L in practice).
- Without replacing the oil filter: approximately 4.0 liters (roughly 4.0–4.2 L in typical service scenarios).
These figures cover the standard 2.2 i-DTEC installations found in models like the CR-V and related Honda applications. Actual capacity can vary depending on the exact engine variant, year, and regional specifications.
How to verify the exact capacity for your vehicle
To confirm the precise oil capacity for your specific car, consult the owner's manual or the official service information for your model year and market. If that isn’t available, contact a Honda dealer or a trusted mechanic and ask for the engine oil capacity with and without filter replacement for your exact VIN and model configuration.
When performing an oil change, always fill toward the upper end of the recommended range with the filter replaced, then check the oil level with the dipstick and top up gradually as needed to reach the correct full mark.
Summary
For the Honda 2.2 i-DTEC, plan on about 4.5 liters of oil when changing the oil with a new filter, and around 4.0 liters if no filter change is performed. Confirm the exact figure for your vehicle version in the manual or with a dealer, and always verify oil level after filling to avoid overfill or underfill.
Is the Honda 2.2 diesel engine a good engine?
The 2.2-liter i-CTDi diesel engine is known for its reliability and efficiency. It produces around 140 horsepower and 340 Nm of torque, which is more than adequate for daily driving and occasional long trips.
How much oil does a Honda I DTEC engine take?
The quantity needed to change the oil in your engine is 4,7 litres.
How much oil does a Honda 2.2 I DTEC take?
The quantity needed to change the oil in your engine is 5,5 litres.
How much oil does a 2.2 diesel engine take?
Capacities and Specifications - 2.2L Diesel
| Item | Capacity |
|---|---|
| Engine oil with filter. | 7.68 L |
| Engine oil without filter. | 7.38 L |
| Clutch fluid. | Between the MIN line and the MAX line |
| Manual transmission oil. | 2.6 L |