The 2020 Honda Pilot with the 3.5-liter V6 engine requires about 5.7 quarts (5.4 liters) of engine oil when performing a full change with a new filter.
Capacity details for the 3.5L V6
Here are the official capacity figures for the 3.5L V6 used in the 2020 Pilot, including the replacement filter.
- 5.7 quarts (5.4 liters) of engine oil with a new oil filter
Note: Always verify the capacity in your owner’s manual or service data for your exact vehicle, as regional specs can vary slightly.
Recommended oil grade and change guidance
To ensure proper protection and performance for the 3.5L V6, follow the manufacturer’s viscosity and change guidelines. The following points summarize common recommendations, but always refer to your specific owner's manual for regional differences.
- Viscosity: 0W-20 is commonly recommended for the 3.5L V6 in the United States; confirm the exact specification for your region in the manual.
- Oil type: Synthetic oil is preferred for best protection and longer life between changes.
- Change interval: A typical interval under normal driving conditions is about 7,500 miles (12,000 km); severe driving conditions may require more frequent changes.
Always verify these guidelines against your vehicle’s owner’s manual, as requirements can vary by market, climate, and trim level.
Practical tips for your oil change
When performing an oil change on the 2020 Pilot, use the correct filter and ensure you refill to the full mark on the dipstick after draining. After adding oil, run the engine for a few minutes, then recheck the level and top up if necessary to reach the full line.
Summary
In short, the 2020 Honda Pilot’s 3.5L V6 engine takes roughly 5.7 quarts (5.4 liters) of engine oil with a new filter. Use the recommended 0W-20 synthetic oil (as specified in your region’s manual) and adhere to the prescribed change interval for optimal engine health. Always confirm exact specifications in the owner’s manual for your VIN and market.